Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Concrete figurine

Posts

Concrete figurine

#1

Concrete figurine

Doug Ridley

How would you repair this little concrete figurine?

Re: Concrete figurine

#2

Re: Concrete figurine

Bill Houghton, Sebastopol, CA

I believe you can get concrete epoxy. Contact a local landscaping supply company.

Re: Concrete figurine

#3

Re: Concrete figurine

Stuart Johnson

If you have a good match between the two pieces you could drill matching holes and epoxy in a bolt. A little on the two pieces as well but don't take it to the edge. Once it's set you can mix a bit of mortar and work it into the crack. Once dry it should look good.

Re: Concrete figurine

#4

Drill, baby, drill !


Re: Concrete figurine

#5

Re: Concrete figure Options

Mark Mandell - Gone Round In New Jersey

A: Leave it the way it is. So the dude got "faced" and somebody lopped his chinwiskers. Tell people who see it that they'll grow back but it'll take a long time. Then . .

B: Go buy another one (as the guy who has the mold needs the money), and put it up next year when you can point out how well the Rogain worked.

Re: Concrete figurine

#6

Re: Concrete figure Options

Pete in Holland

It's a decorative piece. You don't need to drill any holes.

Clean the joint of any remaining loose grit, blow it clean & dry, then just use some slower setting epoxy (1 hour minimum). Be careful about squeeze out though. It won't come off.

My dad epoxyed the corner (8" of the protruding slab) of the front porch slab when his tractor clipped it 30 years ago. Still holding today !

Re: Concrete figurine

#7

Gorilla Glue