Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Crib Rail Router Bit?

Posts

Crib Rail Router Bit?

#1

Crib Rail Router Bit?

Mark Mandell - Gone Round In New Jersey

Anyone know of a router bit made to profile the top of a crib rail so that the teething shield will snap into place? Shield wants a profile that's 3/4" wide by 1/2" tall.

My other problem is that I've made rails from 1" stock but the shields all call for 3/4". I anticipate I be making essentially a piece of molding to cap the main rail and hold the shield.

TIA

m

Re: Crib Rail Router Bit?

#2

Are tehy really needed?

Lee Schierer McKean, PA

I'm not sure I would bother with the plastic cover. As long as the finish is non-toxic, which all of them are, no child is going to chew on the railing very much. Even if they do, the plastic of the finish and wood fibers aren't going to amount to much and probably hurt them. Most kids are out of a crib by age two.

I suspect that the commercial operations use 2 or 3 operations to make the profile and the two slots. A router bit in your router should do the curved top and a 1/16" slot cutter should do the two slots.

Lee

Re: Crib Rail Router Bit?

#3

Re: Are they really needed?

Mark Mandell - Gone Round In New Jersey

Hi Lee,

Depends on the child; some kids (like my son) have a tough time with dentition and will chomp anything they can get their jaws on. I'm also not real happy with the prospect of the top rails on this crib being chewed up.

While I can cut a profile with round-over + slot cutter, the shields are made for 3/4" rails. The crib I'm making has full 1" rails because it's k-d with cross bolts and I wanted the extra beef. I'll therefore be making a kind of mushroom cap molding that will get fixed to the top rails. Haven't decided whether I'll make them removable or glue'em on. Either way, a 1-pass router bit would make life easier when I've made things difficult for myself. :D

Re: Crib Rail Router Bit?

#4

Ellis Walentine

Slotting cutter set, with spacers

Ellis Walentine

If I read you right, that should be a relatively simple operation with a slotting cutter set and enough spacers or bearings to make it exactly the spacing you need.

E