Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Round Sanders?

Posts

Round Sanders?

#1

Round Sanders?

Todd Kudirka

I'm looking to make some table top stands and want to make it to where I have places to set my salt and pepper shakers. I can't seem to locate and sanding device that will allow me to (counter sink) if you will, the wood about 1/4 inch or so in a clean, level way. I guess it needs to be about 3 inches in diameter.

I was think some type of drill press attachment???

Any suggestions?

Thanks.

Re: Round Sanders?

#2

Re: Round Sanders?

Keith Newton

I would use a router with a template to guide the router, if it were me. You can use either a bearing over bit, or a guide bushing in the base.

a good 3" bit is pretty costly, plus they need a lot of power, which you DP may have, but they are more dangerous than most would expect. I have one friend, who lost a finger to one.

Re: Round Sanders?

#3

Easy *LINK*

Mark Mandell - Gone Round In New Jersey

1. Using a fly-cutter [circle cutter], cut a hole the size you want in a block of MDF as a pattern/template.

2. Mount the template on your table top and use a guided router [see link] to cut your depressions.


Pattern Bit

Re: Round Sanders?

#5

JL

Re: Easy

JL

I second this (or third or whatever).

I had to remove a lot of waste in a LOT of wood. I got the 1 1/8" pattern flush trim bit. Worked like a charm.

Re: Round Sanders?

#6

Re: Round Sanders?

Yonak

I had a similar project a long time ago and it was easy enough to do in two pieces. I cut a ring the size of the lip, oversized on the outside, and sanded with a sanding drum on the inside. Then glued it, and tacked from the bottom, to a similarly oversized disk. When dry, I sanded the outside using a sanding jig on a disk sander.

Re: Round Sanders?

#7

Re: Easy

Keith Newton

Mark, did you notice that they bit which you linked to, is shown a bearing on the bottom would be a better choice. And while that bit will work with a template, that long cutting length would need the template to be positioned high above the surface for that 1/4" depth. But that second one down might be a better choice here.