Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Haze in finish revisited.

Posts

Haze in finish revisited.

#1

JL

Haze in finish revisited.

JL

I got most of the haze out of the finish on the altar. I used a steam iron and a clean shop towel. Pressed it several times for a minute or so each time. It worked well for the flat portions. I got the vast majority of the haze out of the finish - there still is some residual "ghosting".

I succeeded somewhat on the flat portions of the trim work - i.e. the parts with a flat bevel. I didn't really succeed with the trim with a little bit of curve - this is also more damaged. I am going to try next week with acetone and possibly some lacquer thinner.

Re: Haze in finish revisited.

#2

Re: Haze in finish revisited.

Bill Tindall

I don't remember this problem discussion but if the problem resulted from moisture and the material is lacquer then a strong solvent of higher boiling point than acetone will work best. "Retarder" which contains high boiling strong solvents will be ideal for the task.

Re: Haze in finish revisited.

#3

Dale Lenz

Agree w/ Bill and will be easier.


Re: Haze in finish revisited.

#4

Re: Agree w/ Bill and will be easier.

Ken Oakley-Sunny St. Cloud, FL

dry it with a hair dryer prior to spraying on finish.