Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Lee Valley "Aluminum Assembly Clamp"

Posts

Lee Valley "Aluminum Assembly Clamp"

#1

JL

Lee Valley "Aluminum Assembly Clamp"

JL

I "succumbed" and purchased a set of 18" and 24" "Aluminum Assembly Clamps" from Lee Valley recently. What the heck, they were on special. I needed some assembly clamps.

They are NOT squeeze clamps. You can't pull things into place with these clamps. What they do for you is hold a piece together and give you a bit of clamping pressure. You have the clamp in the "open" position and slide the business end up to the work snugly. You then "close" the clamp.

They are quick. They exert enough clamping pressure to adequately supplement a good squeeze or bar clamp. They work well.

If you are expecting a squeeze clamp, don't buy these.

It took me a little time to get used to them. But once I did, I was happy.

They were $69 for the four clamps (2 x 18" and 2 x 24"). I don't know if I would pay full price for them, but if they ever go on sale again, I'm going to pick up a few more.

Re: Lee Valley "Aluminum Assembly Clamp"

#2

Re: Lee Valley "Aluminum Assembly Clamp" *LINK*

Dave's Not Here

Are these the clamps you're talking about?


Assembly Clamps

Re: Lee Valley "Aluminum Assembly Clamp"

#3

JL

Yes.

JL

As I said, I don't know if I would pay full price for them, but they have really been nice in gluing up the bars that I'm working on.

They work well for gluing up shelves and tops up to 24". I have made the mistake with squeeze clamps of exerting too much pressure.

Re: Lee Valley "Aluminum Assembly Clamp"

#4

I also like, for assembly, *LINK*

Bill Houghton, Sebastopol, CA

the type of clamp I think of as a picture frame clamp, or corner clamps (linky below, and picture too). They'll hold things at 90 degrees while you organize the serious clamping forces.


img

http://www.adjustableclamp.com/90degreecornerclamp.aspx