Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

cabinet door problem!!

Posts

cabinet door problem!!

#1

cabinet door problem!!

Rick Snyder

Hi All

I have converted an old chest of drawers into a cabinet with glass doors on top and a drawer at the bottom. The doors are inset to the face frame. Prior to staining/finishing, everything fit perfect!. In the final installation of the doors, the left side has "springback" approx. 1/2 inch. I'm using double touch latches(top and bottom) which once closed, should keep the door flat to the face frame but it's the idea that the right side works just fine and left side doesen't. The left door is square and flat just like the right side door is. WHAT HAPPENED?? and what might be the cure?

Thanks, Rick

Re: cabinet door problem!!

#2

what kind of hinge

Bill Tindall

If this is a mortised butt hinge the fix is simple. remove shim and put a piece of veneer under it, then reinstall.

Re: cabinet door problem!!

#3

Re: what kind of hinge

Rick Snyder

Bill, It is in fact a no-mortice type hinge

Rick

Re: cabinet door problem!!

#4

Re: cabinet door problem!!

ben d.

Interested in this one also. Same thing happened to me only it was on a shop cabinet that I painted. Everything was fine until I painted and re-installed the hinges.

I just didn't get into doing too much to correct it yet but beliebe the hinge fits so close that when tightening the 2 mounting screws it pushes through the paint and there is not enough clearence between the hing and fram face for the hinge to pull the door all the way shut.

ben d.

Re: cabinet door problem!!

#5

Ellis Walentine

Interference

Ellis Walentine

If the doors are flat and fit nicely without hinges, I would check is to see that the screw heads are flush with the face(s) of the hinges. If they stick out even a little bit, it could be enough to keep the door from closing flat. If that's not the problem, I'd check to see that the edge of the door is square to the face of the door.

Ellis