Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Speaking of contractor's saws...

Posts

Speaking of contractor's saws...

#1

JL

Speaking of contractor's saws...

JL

The playhouse was gifted with a Delta Model 10 Contractor's saw.

Unfortunately it really belonged to a contractor. It is quite used, rusty and all that.

Most of it I can deal with. The blade elevation is quite stiff though. I have been cleaning it. Any suggestions as to how I can loosen it up? It is really a two handed operation to raise and lower the blade.

TIA

Re: Speaking of contractor's saws...

#2

Re: Speaking of contractor's saws...

Jason Waters

It probably needs taking apart, like the table top removed, a good cleaning, and some grease. You'll probably need some help, and a good mechanical skill, as you will need to re-align the miter slots, etc. possibly depending on how far you take it apart.

Re: Speaking of contractor's saws...

#3

I have to do this every other year or so

Bruce, a MN Galoot

and all it really needs is a good cleaning, as Jason said. Scrape all the crud out, wire brush the ways and gears and use a good dry lubricant on the gears and slots. You'll be pleased at how easily it works. If it's like a lot of job-site saws, it probably hasn't gotten much care over the years.

Re: Speaking of contractor's saws...

#4

JL

Cleaned and lubed, still have problems

JL

The blade tilt is working fine now. The blade elevation mechanism is still really tough to turn. I got a lot of pitch and sawdust off of the mechanisms.

Re: Speaking of contractor's saws...

#5

Re: Cleaned and lubed, still have problems

Carol

Threaded rod slightly bent?

Re: Speaking of contractor's saws...

#7

Re: Or - 2...

Gary Bindel

You might need to pull the shaft out and clean the bearings. I've had it where a buildup of crud(technical term?) forms that makes it hard to turn.

Re: Speaking of contractor's saws...

#8

JL

I'll try that


Re: Speaking of contractor's saws...

#9

try this also

del schisler

also is their a nut to tighten on the outside to keep the blade from lowering when sawing ?? Mine does and here is what i had to do check the end play with the nut and shaft that when you tighen it down and loosen it their is just a little play in it. If it is to tight to start with it will be tight when it is sopose to be loose ? Just a thought . It take a little playing around to adjust it.

Re: Speaking of contractor's saws...

#10

Re: Speaking of contractor's saws...

Charlie Lenz

You may also want to check where the cast arbor assembly pivots. There is a fairly large pin where it pivots that may be gummed up or rusted. Removing the pin is a fairly simple task. First remove the throat plate, remove the blade, lower the arbor and you should see a set screw above where the assembly rotates. Loosen the set screw and pull the pin, you may have to tilt the assembly to pull the pin, I can't remember. Another thing to check is the gear lashes, how the gears mate with eachother. There is a way to adjust the lash, the bushing inside is ecentric. An Owners Manual describes the procedure with pictures.