Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

OT: water leak

Posts

OT: water leak

#1

OT: water leak

Bill Houghton, Sebastopol, CA

I discovered today that we're leaking about 0.40 cubic foot of water per hour somewhere (or more than one somewhere) on our property. Our water system is galvanized pipe* that was installed when the tankhouse had a water tank on the roof and a windmill attached to the side, probably when a car passing through town was a Big Deal; and I've got a saddle clamp on one section of pipe under the house, and have had to make one leak-related repair. So I'm not surprised.

Our toilets aren't running, and interior and exterior spigots aren't leaking (and the water heater sure isn't, as it's brand new); so I am assuming it's one or more underground pipe leaks.

The obvious test, of course, is looking for soggy spots, which was how I found the one leak I had to repair (in the middle of our back lawn) several years back. Are there other magic tricks to know about?

Not looking forward to digging up landscaped front and back yards; really not.

*2" diameter pipe. Our house is higher than adjacent houses of the same (1895ish) vintage. Our son speculates that our house may have been the prime house in a small community water system, as this is otherwise over-sized pipe.

Re: OT: water leak

#2

Re: OT: water leak

Tom Dunlap

You might try your hand at dowsing or water witching....hehehehe...and a pun to boot!

It does work and you don't have to have 'special powers' just learn how to dowse.

Tom

Re: OT: water leak

#3

JL

Re: OT: water leak

JL

I know they "scope" drain line, I wonder if they can "scope" your 2" galvanized line. I've seen the size of the cables that they use - they will fit a 2" line (they fit inside a PVC line).

I just don't know how they would fit it inside your line. Disconnect the meter and feed it through that side may work. I'd contact a plumber.

Re: OT: water leak

#4

Re: OT: water leak

Barry Irby

Do you have an inside main water shut off valve? If so, you could shut it off and see if the leak stops. If It does, then the leak is after the valve, if not, the leak is between the valve and the meter.

Just for giggles I would put some dye in the toilet tanks and see if it shows up in the bowl.

You can use a screw driver as a listening device. Put the business end on the pipe and the end of the handle against the bone at your ear and you can hear the water running. Might be able to track it that way.

Re: OT: water leak

#5

Re: OT: water leak

Larry Clinton At Frankfort, (Central) Indiana

Bill, if your on a municipal water supply, you may want to contact your provider. I'm sure the utility people have equipment that may isolate the line that's leaking. Don't know what all they use - Ground radar might show soaked areas etc. Possibly they have other methods. Such as sound detectors etc. I know I can get equipment to trace a "leak/ground" in a buried electrical cable to within a few feet. I'm sure the water utilities have similar methods / equipment.

Re: OT: water leak

#6

Re: OT: water leak *LINK*

Dick Coers

My neighbor was an old time Ill Bell lineman. In those days, toll lines were above ground everywhere. They were encased in lead and pressurized to keep them dry. He had a listening device that he would use to walk along the line and listen for leaking air. Then climb up and repair. I would suspect that some one makes such a device, or look for an old line man. I loved the guy, like a father. He had stories that just wouldn't stop. He worked in Northern Canada, running line early in WWII up to Alaska. I sure miss him. Found one but it ain't cheap!


Geophone

Re: OT: water leak

#7

Re: OT: water leak *LINK*

John McGaw

I can imagine ways that I might do the job -- inject non-toxic UV sensitive dye into the line for a while and then go over the line's path in the dark with a powerful UV light for example. In theory something like this would work but I don't have the means.

On the other hand, there are companies which do this sort of work all the time. I don't know what they charge so it might be cheaper to just have somebody come in and bury a new PEX line (which is what I did last Autumn) but it couldn't hurt to ask around. Disclaimer: No connection etc.


http://www.americanleakdetection.com/

Re: OT: water leak

#8

Thanks all

Bill Houghton, Sebastopol, CA

There are plenty of good ideas here. I need to do some more preliminary research; but the idea of finding the leak before I start digging is attractive.

Re: OT: water leak

#9

Re: OT: water leak

Bill Tindall

Not what I would do with galvanized pipe. I would replace the pipe and never have this problem again.

Re: OT: water leak

#10

Re: OT: water leak

walta

Since the old pipe is over sized maybe you can pull a new 3/4 pex pipe inside the old steel one. That assumes no T or valves and few bends.

Walta

Re: OT: water leak

#11

That's certainly a possibility

Bill Houghton, Sebastopol, CA

but not one I'm looking forward to.

Re: OT: water leak

#12

Interesting idea

Bill Houghton, Sebastopol, CA

Part of the problem is that I have very limited information on the location and structure of the pipe runs. I know where they come out, but what they're doing between those points is a mystery.

Re: OT: water leak

#13

Re: OT: water leak

C. John Hebert

sound to me like your main line may have a leak...happened to me years ago. Had to dig it all up from the house to the source (well)... the copper had a rock that pushed up against it causing a split. Repaired it and was good after that. The line was 5' down where the leak was. Good luck to you lol

Re: OT: water leak

#14

Re: OT: water leak

Joseph Mulherin

I agree with Bill....replace the entire line ASAP with PVC ...and check if your home insurance might cover the costs.

Re: OT: water leak

#15

Re: OT: water leak *LINK*

Stuart Johnson

I wonder if a thermal leak detector would work. The wet area would be cooler than the surrounding soil. As far as the pipe location it is probably in a fairly straight line from the meter box to the house.


thermal detector

Re: OT: water leak

#16

Re: OT: water leak

Joseph Mulherin

Had a thought....there is a way to use a "tractor" to dig down and pull the line thru the ground without having to dig up the trench. You could just pull a new line whereever you wish and just abandon the old one. I would check around with the electrical people who do this work for underground services.

Re: OT: water leak

#17

Irrigation pipe puller---vibratory plow

Tom Dunlap

If code would let you use the same pipe that irrigation plumbing uses it should be quite cheap to install. Depth might be an issue with frostline though.

Tom

Re: OT: water leak

#18

Re: Interesting idea

Barry Irby

I was thinking about this idea. I am guessing the run is fairly long. Your two inch incoming line is probably very rusted on the inside and may be partially closed off. (Iron expands about five to one when it turns into rust) It might be worth investigating, but I seriously doubt it will be simple to slide a new pipe inside the old one. If somebody had a roto router type device to clean the inside and smooth out the rust-cicles on the interior it might be possible. My usual experience with this is they charge so much more for the high tech approach its just as expensive as the old fashioned brute force approach. Still might check it out.

Re: OT: water leak

#19

Re: OT: water leak

Dave Bair, Eaton Rapids, MI

In any case, I'd be boiling my drinking water; the possibility of contamination is pretty high.

Re: OT: water leak

#20

Re: OT: water leak

Jay Lombardo

Just another thought. When all the other things are considered ( trenching, bedding, installing, backfilling, resurfacing, etc.) directional boring a new 1 1/2 poly line might be the best and most cost effective way. We use the boring for running conduits mostly, and watching a good operator pop it up right where he wants it is pretty cool and saves TONS!!! of work. Just a thought

Jay

Re: OT: water leak

#21

This is CA

Bill Tindall

The frost line is probably 1/2" deep, if at all. If it weren't for mowing over it, it could lay on the ground. I could dig 100' of ditch for a water line in a morning with a 4" nursery spade and have time left for a nap. Which is why I would be replacing the galvanized line with a PVC or copper line and putting an end to ever needing to deal with this problem ever again.

Re: OT: water leak

#22

Indeed

Bill Houghton, Sebastopol, CA

We do get frost - "sunny California", where it never freezes, is down south (although the passes north of Los Angeles got nailed today, major snowstorm, snow down to 2,500 feet, chains, etc.). But I'm not sure we even really have a frost line.

Local code requires water pipe be buried 12" below finished grade; that and getting under the foundation will be the controlling factors, if we do have to replace it.

Re: OT: water leak

#23

Or...use an Airspade *LINK*

Tom Dunlap

There are a couple of tools that use a trailer mounted high PSI/CFM compressor to run a sprayer.

Google:

Air Knife

Air Spade

A lot of tree care companies have them and would be tickled to spray a trench for you. It is amazing how quickly it works. If the soil is bone dry you should water it. If its clay dampen it...you know how clay is...brick to pottery with only three drops of water.

I made two of them using black iron pipe and a spring loaded valve. I know many arborists who just use a quarter turn ball valve though. For about $20 in brand new parts, less if you're a scrounge like me, and about $120/day rental on the compressor...you have a water line set.

The link is to a thread on my forum showing what I made.

You can underbore the sidewalk too.


HomeSpade