Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Chess board autopsy.

Posts

Chess board autopsy.

#1

Alan Young

Chess board autopsy.

Alan Young

My grandfather made this chess board about 45 -50 years ago. I took it to school for Show and Tell when I was in early grade school. It was dead flat when I brought it to school. The teacher placed it on a radiator after S&T and left it there for the rest of the day at which time it had warped considerably but the miter joints never opened. I took it home and after some time- a day or a week? it flattened out but developed a crack right down the middle. It has remained like this for over 40 years. It looks like Grampa glued this up with the grain in all the squares running parallel. The board is made form Maple and Walnut aprox 1/4 " thick. I have made several chess boards but all with veneered tops. I'd like to make one now from solid wood much in this fashion but with a slightly wider boarder. Aside from NOT placing it on a steaming radiator, will it remain flat and miters closed?

-Alan


Re: Chess board autopsy.

#2

I would guess...

John in NM

That the crack is due to the squares wanting to shrink and the mitered edge pieces resisting the movement. There are several potential ways around this, depending on the look you want. Easiest is probably to make the board as a floating panel in the mitered frame. The radiator treatment was pretty extreme... I'm guessing the teacher wasn't a shop teacher :D

Re: Chess board autopsy.

#3

Re: Chess board autopsy.

AZ in Colorado Springs

I made a chess board similar to this one about two years ago. Resawed some oak board boards, glued them into a panel and planed the panel smooth, to about 3/8" thickness. Used walnut and aspen for the 1-1/4" squares, (1/4" thick), with opposing grain direction for the two colors. There is brazilian cherry trim all the way around, about 1" wide, w/ mitered corners. The entire board is about 12" square.

It sat in the back seat of my pickup truck one warm and sunny Sunday morning for a couple of hours, and the oak panel warped (got warm in the truck while I was in church). Sitting on the table the center of the panel is probably 1" off the table (I still have it somewhere but haven't looked at it for a while.) I tried to flatten it with some wet towels, but it has never moved again.

The interval from gluing the panel to completing the chess board was several weeks, so the wood was dry and acclimated, and the glue was completely cured. Never could figure out what happened to make the board warp. It was quite warm in my truck that day, but here in Colorado Springs, the humidity is quite low.

The replacement chess board (this had to slide into a box) had a piece of plywood for the substrate.

(I'm not trying to hijack this thread, but the post reminded me of this weird episode.)

Re: Chess board autopsy.

#4

Re: Chess board autopsy.

George Colonel's Workshop-Havertown PA

Good Afternoon Allan,

That split would make my heart ache. Wood is going to move no matter how well reasoned your objection. By the looks of it, the substrate cracked and pulled the squares apart. Its stable now that the tension is released.

As it happens, I decided to make one more board for an old Air Force buddy who lives in Oklahoma. I am going with 3/8 thick squares of tiger maple and bubinga, substrated by MDF. I like the grain of the squares running the same way, so will do that.

George