Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

OT: Old Gasoline

Posts

OT: Old Gasoline

#1

OT: Old Gasoline

Stuart Johnson

Would it be safe to use about 3 gallons of old gas with a half tank of new in the truck? After spending way too much to have the fuel system on my riding mower cleaned as a result of old gas gumming up the works I don't want to think about what it would cost for if I mess up the truck fuel system.

Re: OT: Old Gasoline

#2

Jason Roehl in Lafayette, IN

Re: OT: Old Gasoline

Jason Roehl in Lafayette, IN

Dump it in the vehicle and don't give it a second thought.

The problem with small engines is that the lines and metering parts are all tiny, so they clog easily. Not so with vehicle engines.

Jason

Re: OT: Old Gasoline

#3

Re: OT: Old Gasoline

John McGaw

I've done it with no problem in the past. I've even dumped small quantities of pre-mixed 2-stroke fuel into the old Dodge pickup. Just keep in mind that the more fresh fuel in the tank with the old, the better things will work and that adding fresh fuel after the old might help mix things up a bit better.

Re: OT: Old Gasoline

#4

Add gas stabilizer...

paul in AZ

if you are not going to use up a tank of fuel in a couple of months.

Re: OT: Old Gasoline

#5

Another vote for Stabilizer...

Dave Paine

I need to keep gasoline around for my portable generator as well as push trim mower, small tiller and new snow blower.

I have used the Stabilizer product and very happy to say no issues with gum related problems. The engines start as normal even with months of inactivity.

I put the few ounces in the 5 gal can before I fill and then I know any machine is going to be protected.

Re: OT: Old Gasoline

#6

Dilution is the solution for pollution

Tom Dunlap

While this isn't a pollution solution...same idea.

Run your fuel tank down as far as you're comfortable. Head to the gas station with the old fuel. Dump it in first then fill the tank. If you really want to be through drive home going across an untilled corn field to get a good shaking ;)

Since I'm not doing treework full time anymore I mix saw gas in small quantities, half and one gallon batches. Any extra mix gas goes into my truck tank at the end of the day if I'm not going to cut again in two weeks. When I've talked with friends of mine who are Husqvarna and Stihl factory tech employees they've all told me that a month is about as long as you want to have any fuel sitting around.

The tiniest bit of 'pollution' from mixed/stale gas won't have any affect on your vehicle if its diluted.

Tom

Re: OT: Old Gasoline

#7

Fuel injection's got pretty small "ports," too

Bill Houghton, Sebastopol, CA

Fuel injection systems - on all or darned near all modern cars/trucks - can clog pretty easily.

The problem with old gasoline is that the deteriorating compounds can form a kind of varnish. I'd be reluctant to put old gas in anything except my early 70s pick-em-up truck, which has a carburetor.

Re: OT: Old Gasoline

#9

Jason Roehl in Lafayette, IN

But...

Jason Roehl in Lafayette, IN

...there are two major things working in one's favor for old gas being poured into a vehicle fuel tank. One is that virtually all vehicles now have an in-tank fuel pump with a screen on it, plus an inline fuel filter somewhere before the engine. No particulate varnish should make it through both of those. Secondly, fuel injection systems tend to run at a much higher pressure than a carburetor's fuel system--roughly 35 psi minimum vs. 5-10 psi or so. Never mind the tiny diaphragm pump on a lawnmower engine. (And if the vehicle is direct-injected, as modern diesels, and a handful of gas, the fuel system pressure is upwards of 20,000psi). On top of that, even if there is a small amount of varnish beginning to form in a 1- or 5-gallon gas can, mixing it with 10-15 gallons of fresh gas introduces a bunch of solvents and detergents that will probably break any varnish down in short order.

Jason

Re: OT: Old Gasoline

#10

Re: OT: Old Gasoline

Randy

How old is old and how much does tank hold? If it was the old blend with mtbe in it it may not mix well with the ethano, blends.

Re: OT: Old Gasoline

#11

Re: OT: Old Gasoline

TomD

I don't pretend to know anything about this, but had to research it recently after seeing something about it on a ATOH episode. Two new problems came up. Gas is a lot less long lived, 6 weeks max, which frankly doesn't correspond with what I have experienced. Second the stuff with ethanol in it collects water, so if you have been cycling gas through a can there will tend to be water build up down there. Gas stabilizer helps, but there are two kinds, I think red and blue, and only the blue will help with the water/ethanol problems. I don't know how that tracks across the country, but at the very least i am now going to be trying to source the ethanol free stuff for my small engines, and I will be reading the labels more carefully when buying stabilizer.

http://video.pbs.org/video/2190819128

Fuel starts around 20 minute mark.

Funny part is that my local province has a FAQ on gas, lots of happy happy. Then when it comes to aircraft, they just flatly say do not use the ethanol stuff. Aircraft operating environment is a lot different. And I hear this carries over for craft that use 2 cycle engines, where some truly odd things happen in the air that do not happen on ground, but it still made me think that it sounded a little fishy.

Re: OT: Old Gasoline

#12

Re: OT: Old Gasoline

Tom Dunlap

I'm a 'TomD' too so when I see one of your posts I get a hitch-step!

Most 2 cycle oil has stabilizers included. They die the gas so that most people won't use straight gas. Chainsaws make really funny noises running on straight gas...followed by awful noises...followed by silence!

A few years ago I had an ATV that was running poorly. To me it sounded like gummed carb. In order to get to the carb it meant disassembling about 1/4 of the machine...at least that;s what it seemed like. After 'going in' three times to clean, reclean and reclean again I had the light bulb go off. Try some high octane pure gas. This advice came from service reps from Husqvarna and Stihl, they know their stuff! Since this was a 4 cycle it didn't enter my head to try this. After the last assembly I put some high end gas in the tank, not full. It started up and ran great! To give it a test, I drained that gas out and put in the low end gas. Ran crappy...drain and refill. Runs like a champ. From then on I only used the expensive gas in my small engines. The cost difference is negligible.

Tom

Re: OT: Old Gasoline

#13

Re: OT: Old Gasoline

Philip Duffy

Solved my small engine problems by going to the local airport and buying a can full of 100 octane aviation gas. End of problems! No corn, no problem, no gum, starts every time, all machines.

Re: OT: Old Gasoline

#14

Re: Another vote for Stabilizer...

AZ in Colorado Springs

At the end of the summer I empty the gas can into my truck (at the gas station, just before filling) so the next season I can have fresh gas for the lawn mower. Same with the 1/2 gallon or so of 2 cycle gas left over from the weed whacker. (I have no snow blower or generator so I need not have gas available during winter.)

You could do something similar a couple of times a year to ensure fresh gas is available for the generator and other machines. If stabilizer works for you then great, no need to change anything. I'm just suggesting a way to "rotate the stock" and not need to introduce a separate component.

Cheers

Re: OT: Old Gasoline

#15

Jim DeLaney, Austintown, Ohio

Re: OT: Old Gasoline

Jim DeLaney, Austintown, Ohio

I've never really had a problem with old gas. The stuff I use doesn't have alcohol in it, though.

I use Stabil in everything. Put it into the container before I add the gas, so I'm sure it mixes well and thoroughly (although that shouldn't be any problem anyway.). That said, my cans of gas seldom last more than a few months anyway.

Straight gas in lawnmower and rototiller all Summer, and occasionally in the chipper/shredder. In the leaf vacuum during the Fall and in the garden tractor year-round.

The 50:1 mix gets used in the chainsaw (intermittent use), leaf blower, Mantis, and weedwacker (about 9 months out of the year) and the snow blower all Winter. Never a 'bad gas' problem in probably fifteen years of doing it this way.

Stabil is definitely your friend!