Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Router Table Fence

Posts

Router Table Fence

#1

Router Table Fence

Tom Rex in TX

Does anyone have or know where to get detailed plans for an excellent router table fence with micro adjustment?

Re: Router Table Fence

#2

Re: Freud Router Table Fence

Charlie Lenz

For less then $100 the Freud is hard to beat if thats what your looking for. I have one and I like it. But I'm not exactly sure if thats what your after other then plans. Were you looking for something similar to the Incra ?

Re: Router Table Fence

#3

Re: Freud Router Table Fence

Tom Rex in TX

I'm looking for one that I can build myself.

Re: Router Table Fence

#4

Re: Router Table Fence

Gary Smyth

ROUTER TABLE MICRO-ADJUSTER

www.woodsmithshop.com/download/207/micro-adjuster.pdf

You can peek at the one above offered on the net.

In my experience you don't really need a micro adjuster. As long as the fence is substantial, perpendiculer to the table, free to move, and can be locked down (I use a slot and plastic knobs, fender washers, with a 1/4" stud, and insert permanently set in the table) you can eyeball and then run a test piece. It's just as fast and accurate and there is no futzing with screws and springs, etc. And since the wood passes the cutter on a single point throughout the pass, the fence doesn't always have to be parallel to the miter slot (unless you are using the miter gauge to hold the piece to the fence). Oh. and since I laminated a white piece of formica on the top when it was built, if I have to duplicate a cut or just play with it a bit, I draw a pencil line on the top and use that as a base point to make further adjustments. I use soft color pencils on occasion to keep track of the "correct" line if I have to go back after an initial setup.