Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

OT - telephone wiring

Posts

OT - telephone wiring

#1

OT - telephone wiring

Bill Houghton, Sebastopol, CA

It appears that I may need to replace the wiring from the phone box to the phone outlets in our house. We have DSL on the phone line so that I can type these words into the interweb.

I hear conflicting things: that there's a higher grade of wiring from the phone box to the phone outlets, suitable for DSL, and that the old-fashioned stuff that's been around for years is what you use.

Any information on this would be much appreciated; also, any suggestions of good references for phone wiring. I'm familiar with electricity; not so much with phone stuff.

Re: OT - telephone wiring

#2

JL

Re: OT - telephone wiring

JL

CAT 5 cable can be used nowadays.

You can also use something like Beldin 9729 (shielded twisted pair).

Re: OT - telephone wiring

#3

Re: OT - telephone wiring

John McGaw

DSL 'exists' for the span up to the DSL modem and no further -- that is why you are required to install filters between the line and each phone in a standard DSL installation. Thus, any high-quality wiring meant to assist the DSL transmission isn't needed all over the house. Personally, I ran CAT5e cable from the telco demarcation box to the equipment closet where the modem and the majority of the distribution equipment lives. The CAT5e goes into a patch panel and then to the modem and all of the other phones are wired into the patch using standard old-style (cheap) cable which is more than adequate. All of the DSL filtering is done at the patch rather than being scattered around the house.

Of course I'm a nerd...

Re: OT - telephone wiring

#4

Re: OT - telephone wiring

Stuart Johnson

When we got our DSL we had to install filters on all phone outlets. This worked but we kept having speed issues. The ATT repairman finally installed a filter outside and we have not had any real problems since. Our wiring is the original 1985.

Re: OT - telephone wiring

#5

Re: OT - telephone wiring

John McGaw

AT&T seems to be spotty about practices in this regard. My local provider (BellSouth) informed me that they do not use outside band splitter. Period. End of discussion. I very nearly went and bought my own to install but then decided that having my patch panel and all of the filtering in one place indoors would probably be nearly as good. So far it has worked out well.

Re: OT - telephone wiring

#6

Re: OT - telephone wiring

Bill Houghton, Sebastopol, CA

Thanks, John. I'm not a nerd*, and our modem sits near the computer, while phones are scattered around the house. Our existing wiring has old-style junction boxes fastened to the sides of joists here and there, as I extended the original, one-line wiring around. These are not weatherproof. The AT&T box has, if I recall correctly from opening it earlier this week, space for four connections. Are there patch boxes/junction boxes suitable for crawlspace installation that would allow me to run one cable to a central point and then radiate out from there?

Put another way, can you suggest the sort of retailer from whom I'd buy this kind of stuff? Radio Shack was the source of the "you don't need but the old cable" advice, and I don't find anything in the local Yellow Pages that points me in any obvious direction as to where to get materials.

*My sons would beg to differ.

Re: OT - telephone wiring

#7

Re: OT - telephone wiring

WarrenJ

Bill,

If you are concerned with the signal for the DSL line only; then I would do the following:

Go to a big box store (Lowes or HD) But some Category 5e cables by the foot. They will also have the jacks needed to terminate the cable at the modem end of the run.

Install the cable from the outside box to the modem. Attach the blue pair to the screws in the box that has

the signal coming in. You should see other wires attached (maybe red and green) .

At the modem end, attached the blue pair to the jack you bought and you should be set to go. No need to rewire the entire house.

Re: OT - telephone wiring

#8

Verizon DSL

Lee Schierer McKean, PA

When we got our DSL several years ago, we opened the box, added filters to each phone, plugged the modem into a phone jack, connected the computer to the modem and we were in business. No wiring changes were needed. We have phone jacks in nearly every room. Our house is wired with the old solid copper four conductor telephone wiring. We've had no speed issues or problems related to this wiring. Any wiring that supports a telephone will support the DSL modem.

Lee

Re: OT - telephone wiring

#9

Actually, the problem is with the phones

Bill Houghton, Sebastopol, CA

We're getting surprise periods of no dial tone, and static when we do have dial tone. Our phone service is through our ISP provider (although provided by AT&T), and they're telling us the tests are showing an "unbalanced" situation in the in-house wiring; and I'm getting clean dial tone at the test jack in AT&T's box.

Re: OT - telephone wiring

#10

Jesper, Denmark

Re: OT Wireless??

Jesper, Denmark

I have a three set wireless phone system, made by Siemens. The master is wired to the ADSL box in the office, where all that electronic stuff is located. The other two are in the living room/kitchen and the third in the workshop.

In summer, we just take a phone outside and get great sound up to 300 feet away from the house. I do have a few old AT+T phones installed in weird places around, using 20 plus old wiring with the old three-prong receptacles replaced with modern stuff. They work fine too.

Phone service is via IP, delivered by the Telco and an ADSL connection, which also provides internet and TV. TV is wired to a separate box from the ADSL with a USB cable.

Raw download speed is around 20 mbit/sec, which is shared by all three services - phone does not use much, so the bandwidth is split about 50/50 between the other two.

Only draw-back I have experienced is that it all stops in a power outage, but those are rare now that all the power lines are underground.

Re: OT - telephone wiring

#11

Re: OT Wireless??

Larry Clinton At Frankfort, (Central) Indiana

Bill, I have a old house (1880's), so have installed most of the phone lines myself as it only had one line into the house when I purchased it. I did install cat 5 cable to my computer and ran a line upstairs to a second computer station (used as a phone line also). I recently purchased a Panasonic wireless system KXTG 6641 which has 1 base station and 4 remote Handsets. Cost was around $200 as I recall. I have one of the remote phones in my shop - a separate building with the remote located about 60 - 70 foot from the base station. All the phones work great. A couple of great features of this unit is that the batteries are standard 1.4 ~ 1.5 Lithium ion type which make replacement real cheap and easy to find. The second feature that I like is that the handset on the base station powers the base when the power goes out. As long as the batteries hold you have phone service - then you can replace the base phone with one of the remote handsets and still have service. It you go this way I would run a line (cat 5) to the base station and your computer - should solve all your problems. You can move the base stations anywhere you have a 120V outlet.- if you have DSL you may have to use a filter on the base station or if the filter is in your junction box, run separate lines to the phone & computer.

Re: OT - telephone wiring

#12

Jesper, Denmark

Re: OT Wireless??

Jesper, Denmark

Not to be picky, but if you get the phone conection through an ADSL modem, as the modem looses 120 Volt power, you do not have the phone connection - even though the phone itself is powered.

Since most also have cell phones, it is not too important to have the 100% uptime on the landline as you have with the old analog phone connection.

Re: OT - telephone wiring

#13

Re: Actually, the problem is with the phones

WarrenJ

Do you pay a monthly fee on your phone bill to cover the inside wiring? If so, have them come out and meter the lines. They should be able to determine where there is a fault. If not, next time you have the noise on the line, go around and unplug other phones to see if the noise stops. That may help narrow down the problem.

Only other solution i can see is to install new cable/wire (Cat. 5e) to each phone plate. Then you would need to punch down on a telco block to tie all together. If you want to run the cables and have someelse punch down, I would look in the phone book. There has to be someone in you area that does voice/data cabling in businesses.

Re: OT - telephone wiring

#14

Let's start simple Bill

Tim Greif - West of Chicago

How many filters do you have - one at each phone? What you're describing sounds similar to the effect of a bad filter. If you have one at each phone, disconnect all of them. Then see if you still have the problem. If you now get a clean dial tone like at the AT&T interface box, then you have a bad filter. Add them back one-by-one until you find the one that is the problem.

As an aside, I wired my house for phones back in '89 using cheap Radio Shack 4-conductor phone cable. I have an interface terminal block in the basement where everything terminates and I run to the AT&T interface box. I only use one filter. It's installed between my terminal block and another terminal block that feeds everything except the computer room. End result is one filter to serve all phones except the line to the computer room. It's been working stellar for years on DSL. Only disadvantage is that when the filter goes, all phones are dead. But truthfully, that makes it pretty simple to diagnose. I got a box full of filters when I got DSL and I just use one of them.

If this turns out to be your problem, I can take a picture of my filter arrangement that allows me to simple unplug the old one and plug in the new one (or bypass it completely).

Re: OT - telephone wiring

#15

Re: OT Wireless??

Larry Clinton At Frankfort, (Central) Indiana

Your may be partially right Jesper, I have the U Verse package from ATT- everything come in on the phone lines including the TV, internet and phone. However they have a fairly large backup battery on the system. Last outage we had was around 5 hours. We didn't loose phone service during that time. Don't know just how long it would last but as you said we do have cell phones if needed. Standard DSL probably would work as you don't need the modem for your phone connection - only for the computer internet line.

Re: OT - telephone wiring

#16

Jesper, Denmark

Re: OT Wireless??

Jesper, Denmark

My DSL modem carries all the data -including phone on IP protocol, and does not have any battery back-up. So no, mains power, no phone.

Re: OT - telephone wiring

#17

Re: OT Wireless??

Larry Clinton At Frankfort, (Central) Indiana

Must be a different system in Denmark, I had ASDL for a few years prior to going to ATT. My phone lines were left intact, and I had previously installed a cat 5 cable to my phone entrance box for my dial up. When they installed my ASDL, that line was dedicated to the modem only. I then fed a new line upstairs for a 2nd computer. The other phone lines (old 4 wire) had a filter installed at the phone junctions on the walls. So if I lost power my phones still worked. At that time I had a couple of standard phones (not wireless) and no cell phone so it was somewhat important that the land line worked. It did all except one time when we had a major ice storm that dropped both the phone and power lines for about a week!