Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Gorilla Glue Discovery . . .

Posts

Gorilla Glue Discovery . . .

#1

Gorilla Glue Discovery . . .

steve mackay

Shipping some pieces to Kuwait and needed some rather large blocks of styrofoam to block them in the box. I get my foam from dumpsters due to my "low overhead" policy and no one seems to discard BIG pieces. I've used other glues but they melt the stuff. Gorilla Glue didn't melt it and its strong, strong, strong. Just thought I'd share this one. You never know.

Re: Gorilla Glue Discovery . . .

#2

Re: Good For Styro

Mark Mandell - Gone Round In Jersey

Sucks (and fails) for wood. I've had to repair several pieces where the joints failed after a couple of seasons' cycles.

m

Re: Gorilla Glue Discovery . . .

#3

Re: Good For Styro

steve mackay

I don't know. It worked great for this. I didn't want to use any nails or screws so I went with the GG.


Re: Gorilla Glue Discovery . . .

#4

Re: Good For Styro

John Lucas

Gorilla glue is just a different formula of the same chemicals used for Great Stuff Foam insulation. Well more or less anyway. Our Chemistry professors also make a special brew of the stuff that expands many times more than Great Stuff.

That's why Gorilla glue foams when it tries to fill a gap. It is good glue when used properly however I haven't found a use for Gorilla glue that I can't do with wood glue or epoxy and either one is far easier to clean up.

Re: Gorilla Glue Discovery . . .

#5

Expanding Gorilla Glue? More info, plz

Tom Dunlap

Is this formula available to non chemists?

Does the expanded GG have the same insulation characteristics of spray foam?

I'm insulating a camper so I could use this stuff.

Tom

Re: Gorilla Glue Discovery . . .

#6

Re: Expanding Gorilla Glue? More info, plz

del schisler

I don't belive i would use it . It is made for glueing wood ect. Their are 2 kind's of gorilla glue their is the white kind that doesn't foam. and the other kind is syurp color and it is the one that foam's. I guess try it ??

Re: Gorilla Glue Discovery . . .

#7

Re: Expanding Gorilla Glue? More info, plz

Mark Mandell - Gone Round In Jersey

NG, Tom, The stuff reacts to water and foams, but not as you think. Plus it would cost you a fortune. You can, however, buy 2-part foam kits that will do what you want. You can also build your trailer and drag it over to an insulation firm, and they'll be happy to pump your walls full of the stuff just as they do with structures.

Re: Gorilla Glue Discovery . . .

#8

Re: Gorilla Glue Discovery . . .

Thomas Skaggs, Foothills of Mount Level

Good to know about the styro application. Thanks

BTW....I never use it for my furniture. Yellow glue and I are very close friends.

T.

Re: Gorilla Glue Discovery . . .

#9

Re: Gorilla Glue Discovery II

Gary Smyth

If ever you have blown out too much drywall or plaster or mortar installing plastic anchors, or even molly and toggle anchors when putting up curtains or hanging stuff. Gorilla Glue applied to an undersized piece of wood or anchor, screw, etc. will fill the gap and hold things tight. Since the hole is already there, spray it with a couple of spritzes of water, coat the bottom two thirds of the item to be inserted with a good coverage of Gorilla Glue, and set it in the hole. Hold temporarily with tape if necessary. In Gorilla glue's cure time, in my experience, better overnight, the glue wiill expand into the recesses and also come toward the wall front locking in the anchor right where you want it. You can then drill a pilot and hang pretty much anything you intended to hang in the first place. It's a one time fix, but none have failed me yet. If in brick or block, I pre-drill a pilot hole in a wood dowel and insert the dowel. Once set a screw put into the pilot hole seems solid as its surroundings..

Re: Gorilla Glue Discovery . . .

#10

! I'd have never thought THAT one up !


Re: Gorilla Glue Discovery . . .

#11

Re: Good For Styro

eliotandmax

Not knowing any better, I once used GG to apply veneer to some MDF. A woodworker salesperson at a store just about laughed me out of his store when I told him about it! But that veneer has held up for years and years.

Re: Gorilla Glue Discovery . . .

#12

Re: Good For Styro

Sgian Dubh

"I haven't found a use for Gorilla glue that I can't do with wood glue or epoxy and either one is far easier to clean up."

John, your statement is a reasonable one, but it does depend on your gluing needs. There is, however, at least one circumstance I can cite where polyurethane adhesives come into their own, ie, bonding wet wood or wood that is only partially dry, eg about 22% to 30 or 35% MC, or thereabouts.

We use such glues on a pretty regular basis when building outdoor furniture or artefacts out of wood that is frequently on the wetter side, even near enough green during construction. The only glue that works satisfactorily I have found is one of the polyurethane glues. Purbond HB is one brand good in these situations, although it may not be available in the US.

It's not surprising that this is the case really as nearly every wood adhesive is formulated to work on dry wood. Dry wood by definition is wood that's been dried to 20% MC or below. All of the regular glues such as PVA, aliphatic resin, urea formaldehyde, epoxy, etc, used on wet wood will almost certainly fail, which I can anecdotally verify. On the other hand, the polyurethane types really do work in these circumstances. You'll see some examples of the type of constructions I'm referring to at this link. Slainte.