Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Mounting router in table

Posts

Mounting router in table

#1

Mounting router in table

Greg Muller

I have a Craftsman router table and would like to mount my new Triton router in it. The mounting plate is metal and was predrilled with countersunk holes for a craftsman router. I would think I could drill holes to match the Triton holes but having never done this before I am looking for a little advice on how to proceed. Thanks.

Re: Mounting router in table

#2

Re: Mounting router in table

Tony - Memphis

A couple of thoughts...to mark your hole spots, I have seen a tip where a bolt that fits in your mounting holes has its head cut off and is filed to a point in the drill press (or a drill). You make however many you need for your base and when you get the router in place, a good rap on the top or even just hand pressure will mark the spots to drill your holes. To center the router in the opening, there is a centering bit out there and you can make your own on the lathe. One technique uses a collar in the table (assuming yours accepts them) and the centering bit is the same od as the collar id. Some have a taper as well. Finding the metric bolts can be tough. Lowes and HD have some in their unique item bins. I have had to oder some too. Good luck.

Tony

Re: Mounting router in table

#3

Re: Mounting router in table

George Colonel's Workshop-Havertown PA

Good Evening Greg,

I had to do the same operation last weekend to my #2 son's router plate. He has a P+C 690. I had a set of brass template guides and one of then fit the opening of the insert plate exactly. I installed the router and base with guide into the insert plate and used double stick tape to prevent shifting. Then I took the assembly to the drill press and drilled through the holes tapped in the router base, using the exact diameter bit. This located the holes in the insert plate so it preceisly matched those in the router base. Flipping the insert base downside-up, I was able to countersink for the flat top screws. No problems: Everything fit as intended, and all was central to the router bit.

George

Re: Mounting router in table

#4

Re: Mounting router in table

Gary Smyth

I don't know which version of a craftsman router table you have but look at both the top and bottom. On some the top has a not only recessed areas to keep screws flush but underneath the screw hole areas are ribbed with extra metal and reinforced. the underneath is uneven. You might want to check. Also is the Triton you want to install soft start? If not the torque of the start on a thin table recessed hole coupled with a heavy router is something you might wish to consider. A separate top with the router mounted to it and that anchored to the table may work better.

Re: Mounting router in table

#5

Re: Mounting router in table

Jason Waters

George,

I'm confused. You don't mean you drilled through the tapped holes in the router base, do you? I'm thinking you removed the baseplate from the router and used it with the bushing to center it in the router table plate, and lined up and drilled through the holes in the router baseplate into the router table plate, matching what was there?

Jason

Re: Mounting router in table

#6

Egg on my face

George Colonel's Workshop-Havertown PA

Thank you Jason,

You are quite correct. I used the router sub-base as a template for screw location in the insert plate. Double stick tape kept them "married" once centrality was achieved.

George

Re: Mounting router in table

#7

Re: Egg on my face

Jason Waters

George,

No egg in my book, I have done it many times, I was just trying to keep him from messing up something by clarifying, it's all good.

I knew what you did by the description, as you have been here many years.

You did what I would have done.

Jason