We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
I have a Inca jointer planer 343.190. It has a 1-phase motor 110 V 60 hz, cutter width 10 1/4", 41" length table, 2 speeds for planing, comes with a 45 degree tiltable fence, Suva guard, chip guard, wood table stand. It has had a couple of years of light use then sat in a garage for 15 years. We lubed it and started it up the other day.Ran some wood thru it and it is working fine. It is in good condition. Would anyone have an idea what this tool would sell for? Thank you for your time and consideration.
They don't come on the market very often, so prices are a bit hard to come by. There are several Inca forums (check Google and Yahoo) where you could probably get an idea of current sales.
This is one fine piece of Swiss made machinery. In good condition, they will bring quite a bit.
I bought a used Inca 570 recently for $300. It had been sitting, unused for several years and needed some work. I have seen used machines in top shape go for as high as $1200. There were (are) two models of the jointer planer: the 570 which has a Tersa quick-change cutterhead, and the 530 (I believe that's the number) that does not have the Tersa cutterhead. The 570 is the more valuable machine.
I've had two of these machines. The first one I bought new in 1978, one of the first ones to come to the US, and it cost $1035. It was the earlier model, with the belt drive and the simpler dust-collection setup. I absolutely loved that jointer/planer. After I lost everything in my shop fire of 1999, I started looking around for another Inca and didn't find one until a couple years ago, when a fellow advertised one here on our Classifieds board. It was the newer, direct-drive model with the gear shift and all the fussy dust chute contraptions. He sold it to me for $700; they originally sold for over $2000. The Tersa head is nice, and the bed length is a bit longer than my earlier machine, but the nylon helical drive gear was toasted when I bought the machine and I had to replace it, at a fairly steep cost. Like Doug mentioned, Eagle Tools is your best source for parts and information on Inca equipment, but parts are getting harder to find as time goes by. I hope I never have to replace anything on this machine again.