Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Nobody had a worse woodworking day

Posts

Nobody had a worse woodworking day

#1

Nobody had a worse woodworking day

Bill Tindall

It was unusually warm, so much so that I could spray the stair treads outside. First I knocked a full gallon of paint off the saw horses and , yes, it hit on the edge and the cover came off.

The treads are 1 1/8" and they teeter on their back edge, enabling both sides to be sprayed and stored till dry. Five freshly painted fell off onto the ground.

Things improved after that. Spray gun cup didn't seal and paint dripped everywhere, but it was hardly noticeable next to the results of spilling the gallon. All's well that ends. I just noticed something sticky in my hair. I suspect it is beige.

Re: Nobody had a worse woodworking day

#2

Re: Nobody had a worse woodworking day

Thomas Skaggs, Foothills of Mount Level

Quit immediately. Go into your house and grab something to drink....just be careful opening it. ;-)

Re: Nobody had a worse woodworking day

#3

What was the word that followed Oh?


Re: Nobody had a worse woodworking day

#4

That's my tactic too....

John in NM

But it usually takes two or three such disasters to make me accept the inevitable :D

Re: Nobody had a worse woodworking day

#5

Re: Nobody had a worse woodworking day

mdclor

Sounds like a normal day to me.........

Re: Nobody had a worse woodworking day

#6

Re: Nobody had a worse woodworking day

Stuart Hough

Cheer up Bill...we've all been there!

Re: Nobody had a worse woodworking day

#7

Re: Nobody had a worse woodworking day

wooden leg

Bill, you could use 5 lbs of ice melter,an axe to chip the still frozen ice away and then have to do it all over again because your wife has a bad ankle and it doesn't move right. It is better for me to be in the hospital then her. This is from the guy that has fiberglass and stainless steel for one of his legs that moves better then her ankle with screws. Dave

Re: Nobody had a worse woodworking day

#8

Re: That's my tactic too....

NickinMass

Two was my rule back when I was a lab rat - it's the signal to accept that nothing good is going to happen today and you're better off putting things away (you won't make any progress, but you won't move backwards either).

Re: Nobody had a worse woodworking day

#9

Re: Nobody had a worse woodworking day

Jesse Cloud

Sounds like Miller time. Been there done that. Isn't it amazing how that can of paint falls in slow motion. Seemed like it took ten minutes to fall from the shelf of the ladder to the drop cloth and somehow it took a gravity defying mid course turn so that the splash could reach the stereo speakers on the other side of the room....

Re: Nobody had a worse woodworking day

#10

Hey Bill, How's the finger?

Barry Irby

Healing well I hope.

I had the experience of working in the shop one night while too tired. As my TS was spinning down I saw my hand reaching out for the blade to stop it quickly. I turned and left the shop. Fled so fast I hardly turned out the lights. Fortunately I stopped before touching the blade and was not hurt, but I had the realization I was not qualified to be in the shop at that moment. Sometimes its best to walk away.

Re: Nobody had a worse woodworking day

#11

Re: Still have all ten?