Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

correctly sharpening lathe tools

Posts

correctly sharpening lathe tools

#1

correctly sharpening lathe tools

Rich

Have two grinders, one with fine white stone which turns at high rpm. The other one from Grisley mfg. a slow rpm. with very fine stone and water dispensed on wheel. Instructions when viewed with Grisley unit shows grinding tools with wheel movement away from grind . I've been told running against the entended grind is the only way to acheive a sharp tool. Which direction should the wheel address tool? THANKS, Rich

Re: correctly sharpening lathe tools

#2

Re: correctly sharpening lathe tools

NickinMass

I think either way works - before I moved to mostly power sharpening (Lee Valley powered sharpener), I sharpened on stones, running the blade back and forth across the stone. BTW, I sharpen on a 3250 rpm grinder with white stones - plenty sharp for me.

Re: correctly sharpening lathe tools

#3

JL

Re: correctly sharpening lathe tools

JL

I have an 8" grinder which runs at 1725 rpm (or 3450 rpm). The wheels rotate towards the tool rest (and the piece). I also have a slow speed water grinder (Tormek) - I currently have that set with the wheel coming towards the rest.

Either way does work though.

Re: correctly sharpening lathe tools

#4

Re: correctly sharpening lathe tools *LINK*

Mark Mandell - Gone Round In Jersey

Rich,

I highly recommend the AAW DVD on sharpening. It will take you through the various tools, the grinds, and tuning up your grinder. This is a basic skill-set for turners, and the videos by several of the best-known turners are very well done.

Go to the link and click on the sharpening DVD. There is a short sample that you can download. You can also get good info by attending a turning club meeting in your area. Takes a bit of navigating on the AAW site, but you'll find a listing of AAW Chapters listed by State on the site as well. Many clubs maintain libraries of videos that members can borrow.


AAW-DVDs

Re: correctly sharpening lathe tools

#5

Re: correctly sharpening lathe tools

John Lucas

I sharpen both ways depending on whether I'm using my 8" grinder, my water grinder or my sanding belts. I don't see a difference. I do tend to sharpen my carving tools with the sanding belt running away from the tip, same is true with the leather strop.

For my turning tools I have done both directions and it didn't seem to make a difference other than my scrapers. I like the wheel coming into to tip. It seems to produce a stronger burr.

Re: correctly sharpening lathe tools

#6

Re: correctly sharpening lathe tools

Bill White

Rich, I've been updating my sharpening stuff for the lathe tools. A shop-made Ellsworth jig, wheels, etc. I find info about grinding, angles, profiles all over the spectrum. I use a high speed grinder and a Makita horizontal water system.

I am of the opinion that every turner uses what he/she is comfortable with. Not much of an answer, but there sure isn't a fixed method that I've found. Plus, you could spend your way into bankruptcy buying stuff.

Bill