Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Dewalt 733 planer problem

Posts

Dewalt 733 planer problem

#1

Dewalt 733 planer problem

NickinMass

Anyone ever have a problem with drive cogs breaking on a Dewalt DW733 planer? I was running some poplar through last week - I heard a "crack" about halfway through a board and the planer stopped feeding (it didn't bog down - it just stopped when the click happened). Got the cover off and found the cog on the drive was broken. I replaced the cog and the drive chains (figured they might be stretched and they were less than $5 each), got it back together, and the same thing happened on the first board I tried to send through.

I can turn the feed rollers by hand (they don't spin freely, but I don't know if they are stiffer than normal, never having had cause to disconnect the drive chains before), and they were fine until I fed the first board. Any thoughts?

Re: Dewalt 733 planer problem

#2

Re: Dewalt 733 planer problem

Jim Dillon

NickinMass,

This was a design problem in the 733. My 733 drive cog broke as well after a year or so of hard use. Fortunately, I had a local Dewalt service center and they replaced just the cog. It has been just fine ever since.

Jim

Re: Dewalt 733 planer problem

#3

Re: Dewalt 733 planer problem

NickinMass

I'd read a little about the problem, but I was (understandably, I think) a little thrown when the second cog broke. I think the second cog that broke was one of the originals (I didn't pay attention to where I put the cogs, as they are all the same part no.), so maybe I just need to replace them all (the part is about $4 - I probably should have bought four and replaced them all the first time).

Re: Dewalt 733 planer problem

#4

Re: Dewalt 733 planer problem

Jim Dillon

That was really bad luck to have the replacement cog break as well. It has been so long since I had mine replaced that I don't recall if there was any drive chain adjustment to also be made when a cog was replaced, but I don't think there was. Puzzling. Sorry I can't be more helpful. Maybe the third cog will be the charm :) .

Jim

Re: Dewalt 733 planer problem

#5

Re: Dewalt 733 planer problem

George Colonel's Workshop-Havertown PA

Hello Nick,

Both my son's DW 733 and my own have had cog problems as you described. Ken's went first, and he ordered replacements, as well as a couple extra. When mine went South, he had the parts on hand. With new parts, they work perfectly.

George