Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Framing for Door

Posts

Framing for Door

#1

Framing for Door

Kelly M. Robison

Hello All, I am building a wall in a garage; dividing it in half. I want to put a door in the wall and am going to rough in the faming for a pre-hung door. My question to all of you experts is: In the past I have always used the measurement of 82 - 1/2 inches for the door height; BUT since I want the door to sit about 1/2" above the concrete floor do I just shorten it down accordingly???? Maybe; it is so simple I'm just over looking something. Ask me how to turn a bowl and I can give you all the instructions; but I haven't framed a door in over 20 years. All I plan to have on the bottom of the door is a "sweep" because I want to roll tool chests from one room to the other without a door sill in place. Thank you,

Re: Framing for Door

#2

Re: Framing for Door

Charlie Lenz

If you use an interior prehung door you shouldn't have to do anything other then install it. There are no thresholds on interior doors.

Re: Framing for Door

#3

Re: Framing for Door

Barry Irby

You can frame the opening +2" in each direction. +2 1/2" on the height is fine also. Most Interior doors are 6' 8" tall or 80" so your 82 1/2" would be fine.

Re: Framing for Door

#4

Re: Framing for Door

wooden leg

When I put in my dividing wall, I had a normal walk through door, I then built a cabinet that would not fit through either walk through doors( I have 1 that goes outside).

i took the inside door out and put in a curtain for a door. My 2 cents say think about the future. Dave

Re: Framing for Door

#5

Re: Framing for Door

Gary Evans

Kelly,

I would go ahead and buy the door you want to use, then frame your wall to make it fit the way you want.

Gary