Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Chest done at last

Posts

Chest done at last

#1

Chest done at last

Bill Tindall


Once again I am reminded of the skill and equipment needed to take good pictures of furniture. Try as I might I was unable to capture the figure in the drawers. They just look muddy in this picture.

The finish is a pigment stain with alkyd varnish. Hardware is Lee Valley. I thought the dark bronze set a mood for the piece to be a bit more modern than a polished brass look. I had considered African Blackwood handles but settled for these. The vertical spacing is offset proportional to distance from the floor. The bottom handles are 1/2" above center shrinking to centered at the top. One can spend a lot of time diddling with hardware locations to "get it right".

I may yet rub the finish out to a more subdued luster, but doing so will also subdue the wood's figure.

Re: Chest done at last

#2

Re: Chest done at last

John Pappas

Love the clean simple design. Will fit in anywhere for years to come.

Re: Chest done at last

#3

Re: Chest done at last

George Colonel's Workshop-Havertown PA

Hello Bill,

That chest is a lovely expression of art. I wouldn't fret over any perceived perfection shortfall. I like the finish just fine. And the figure of the wood is done justice by the beautiful proportions of the piece. I'd be proud.

George

Re: Chest done at last

#4

Re: Chest done at last

GolfSteve in Calgary

Beautiful, especially the wood for the two top drawers.

Steven

Re: Chest done at last

#5

Love it!

Mike Farinella

Well done Bill (as usual). More pics (inside/drawers) coming?

Re: Chest done at last

#6

Re: Chest done at last

Mark

Gorgeous

Re: Chest done at last

#7

Re: Chest done

Mark Mandell - Gone Round In Jersey

A reserved, "quiet" design finished to suit. The piece will serve without demanding attention except from those who appreciate the craft.

As to the figure and photo, try positioning your lightsource so that it strikes from the side and in front of the piece, along the direction of the wood grain. Play with the angles from say 45 to about 80 off the front surface. The top-light in the pic, coming down and "cross-grain" will tend to wash out the figure. This will also be controlled by the refractive index of your finish film. A lacquer or shellac finish, forming a single optical layer as it does, will reflect light very differently than will a built-up, multi-layered varnish. A rubbed out film, with a different amount of light being reflected back and forth inside the finish layer, will be different still. If your camera will allow different aperture settings, try shooting from a tripod at f/8-9. Most digital lenses operate better at that opening, and you'll get better depth of focus giving you a sharper image for better detail.

Re: Chest done at last

#8

Thanks...

doug f, san clemente, ca

Bill - It's been most enlightening following the process of this piece from start to finish. I picked up several very useful tips.

The finished product is wonderful; well designed, well executed and beautifully finished.

Thanks for the tutorial and keep up the good work.

Doug

Re: Chest done at last

#9

Beautiful!


Re: Chest done at last

#11

Home Run

Thomas Skaggs, Foothills of Mount Level

Bill,

Sweet job there. The joinery looks great and compliments the design very well, as does the hardware.

Thanks for posting!

Tom

Re: Chest done at last

#12

Next up.....

Bill Tindall

stair treads and base trim for the family room.....boring!

But I intend to build another chest of drawers like this one but with cock beaded drawers and crotch walnut faces. Or, it may be a thing with a combination of doors and drawers to ft at the end of a twin (kids) bed.

BTW, much thanks for the feed back. Sometimes I wonder if anyone has read some of my ramblings on constructing something.

Re: Chest done at last

#13

You must have tuned in late

Bill Tindall

If you search my past posts you will find every detail of this thing posted. And before that a bow front chest of drawers.

There will be a quiet spell coming up as I do some house work on the family room. The 19 year old "temporary" stair treads of rough #3 common poplar need replacing, for example. Boring stuff.

Re: Chest done at last

#14

Absolutely Fantastic

Ron in Sterling, CT

Bill, that chest turned out to be a woodworkers dream. Congrats on a job well done. AND thanks for the many posts along the trail, so we could better understand how it all came together.

Ron

Re: Chest done at last

#15

Super Job!


Re: Chest done at last

#16

Nice job Bill,

Keith Newton

You should plan to shoot it again a year from now, when the wood has done its thing.

I like the clean look, and you did an excellent job choosing the wood.

Re: Chest done at last

#17

And I thought the picture looked good

Stephen Kirk

Thats a great looking piece. The handle placement is so subtle you don't notice they aren't the same, which is a neat effect.

Re: Chest done at last

#18

Re: Next up.....

Stephen Kirk

You give so much detail I hope they are all read.

Re: Chest done at last

#19

Re: Chest done at last

Philip Duffy

WOW!

Re: Chest done at last

#20

Re: Chest done at last

Bruce, a MN Galoot

That is really nice work, Bill! It is an extremely well integrated piece with no element clamoring for attention. I particularly like how you handled the transition from the top to the bull nosing under it. It turned out well. I doubt anyone would recognize the anxiety that particular piece caused you.

Nice job!

Re: Chest done at last

#21

Nice work Bill!!


Re: Chest done at last

#22

Thanks all.....

Bill Tindall

If anyone wants dimensions I would be glade to supply them.

Re: Chest done at last

#23

Kneale Brownson

Watching this piece develop

Kneale Brownson

over recent months has been wonderful, Bill.