Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

chairs

Posts

chairs

#1

chairs

Joseph Mulherin

Started in making my first rocking chair today. Bought the DF 2x6x8ft, 1x4x8ft, and cut the boardes to lengths needed for the vqrious parts; glued up the parts to get correct sizes; made some patterns using poster board paper/cardboard bought from WalMart. Traced out the patternsw on the various parts and am waiting for a couple new bandsaw blades to come before I start cutting out the patterns. Am going to resaw the 2x6s on the bandsaw, then setup and use my Shopsmith planer to size the various parts.

I a;ways make patterns for projects so I can work out any problems ahead of time, and still have some from about 25yrs ago I couold use to make the projects again if needed.

When my grandson comes in this week he will show me how to make and send pictures to the WC website.

Re: chairs

#2

Re: chairs

Joseph Mulherin

Laid out the seat shape and setup my Shopsmith into the drilling mode and used a 1 1/4' Fortsner bit to hog out most of the seat depth at various depth from 1" at rear to 1/4" at seat front. Will have to finish with a hand drill because the Shopsmith table space does not allow me enough room to get to the inside sections.

Got my new bandsaw blades in the mail and shall setup the bandsaw with the 1/4" blade to remove most of the underside of the seat at a 45 deg. table setting, then shape up using my small hand plane.

Bought a sanding scorp for my angle grinder which I shall smooth out most of the seat top, then sand with the ROS at different grits until smooth as a babies bottom. Leg holes will be drilled at 17 x 6 deg. and coned out to about 6 deg for tight fit of the leg tenon into the seat.

Have also laid out my own design for the back splat center board and two adjoining splats They have to be worked with the drillpress and scroll saw. Then use my new 1/2" bandsaw blade to resaw the 2x6 into two pieces...that makes me have another design already done for the next chair.

Rockers, arms, seat top board already laid out ready for the bandsaw cutting.

Project is coming out as I had it planned out in my mind...and am satisfied so far.

Will try to post a picture of chair as soon as possible before staining and polying.