Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Buliding a "weight truck" ideas sought

Posts

Buliding a "weight truck" ideas sought

#1

JL

Buliding a "weight truck" ideas sought

JL

Need to build a weight truck for the stage weights.

I have the casters (5" heavy duty). The weights weigh about 15-20 lbs each and are slabs of iron with notches to fit in the carrying arbors. We have quite a few hundred lbs. They are about 15" long x 5" wide x 1" thick.

Thought #1 - 2 x 10s or 2 x 8s flat with suitable bracing tying the two boards together. Lag the casters into the bottom boards. Have two 2 x 12s on edge to keep the weights from sliding off front and back.

Thought #2 - 2 x 4s on edge glued together as the bottom boards. Have 2 x 12s as the end boards.

My concern is breaking the bottom boards if I use the 2 x 10s flat. If I make the weight truck long enough (say 20" between the end boards) - we are talking about maybe 80 lbs per layer. By the time you get up to six layers we are talking about 480 lbs. Do ya'll think a 30" piece of 2 x 10 would break under that load?

Re: Buliding a "weight truck" ideas sought

#2

Re: Buliding a "weight truck" ideas sought *LINK*

Stuart Johnson

This might be a time to buy rather than build. Something like one of these from Northern Tools might fit your needs.


Platform Trucks

Re: Buliding a "weight truck" ideas sought

#3

Re: Buliding a "weight truck" ideas sought

Bill Tindall

Not if it is fairly knot free yellow pine

Re: Buliding a "weight truck" ideas sought

#4

Re: Buliding a "weight truck" ideas sought

nickb

I would worry less about breaking the lumber than sagging. I have a sheet goods cart that is a piece of 3/4" ply (5 or 6' by about 3') on top of a 2x4 frame - works great and definitely carries more than 500 lbs when loaded up. No real sagging issues because the weight is well distributed.

My one reaction to your ideas for construction is that you will need straight dimensional lumber, which I haven't seen in a lumber yard for some time.

A couple of thoughts:

1) build a torsion box out of 1x4s and plywood - if I understand correctly, you are looking at a pretty small platform, so this shouldn't take too much effort (of course, you'll probably have to joint the 1x4 stock straight)

2) hunt up someone with welding skills to knock up something for you