We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
I'm looking for an electric branding iron to emboss a very simple logo on projects. Everything I find on the web is $150-$200; way too much for the small number of projects I want to "brand."
Anyone have any suggestions for a supplier or an alternative way to do this?
If you have a propane torch, the non-electric ones are cheaper. I've never used one, but I regularly heat the soldering copper* I use for sheet metal soldering with a propane torch. Takes a little while, but works fine, and you wouldn't need the tighter temperature range that soldering requires; just get it hot enough to burn the wood. Finding a piece of sheet metal or a small stack of firebrick that you can use to make an "oven" will speed the heating process.
*I understand from Bruce Haugen (MN Galoot) that his dad called these soldering "irons." I learned "copper" during my brief stint as a sheet metal worker, and it is more nearly correct, since the operating part is copper; see picture below. If you have hand metalworking skills (hacksawing, filing) and can find one of these cheap, you probably could whittle your own branding iron (copper). I don't know if you folks down south have garage sales in the winter; up here, except for estate sales, people tend to stop by Christmas and then lay off until later into the New Year; but I do find them from time to time at garage sales, usually cheap.
I think Roeckler still does it, or you can take wood discs to your local trophy shop. They can laser engrave wood discs, that can then be inlaid into a forester bit hole in your work.