Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Releasing Epoxy.....

Posts

Releasing Epoxy.....

#1

Releasing Epoxy.....

Barry Irby

I am making boxes for Christmas gifts. They are about 8"x13" by 4" tall. Have cut off about the top inch for a lid and made wooden hinges. Mortise the hinges into the backs of the boxes and glue them in with epoxy. Wanted to use colored epoxy to fill the tiny gaps around the hinges. Now that the clamps are off I discover the lids don't sit level. These boxes are in book matched pair and one is gapped up about a tenth of and inch on the front left corner and the other on the front right corner. Any chance of using a heat gun to remove the hinges and set them again? Any easy way to reverse the epoxy?

Or would you hand plane the high corner and call it good?

Re: Releasing Epoxy.....

#2

Re: Releasing Epoxy.....

Bill Howatt

Heat is always my first thought but I've never done it with anything pretty before and there was always a piece of metal involved. As a precaution I would mask the area around the glue joint with some scrap. I can tell you that some epoxy is harder to break than others but it may also come down to how old the joint is.

I don't know about using chemicals but there may be something.

Best I can do. Good luck.

Bill

Re: Releasing Epoxy.....

#3

Heat works extremely well

john lucas

It doesn't have to be very hot to break the bond. Use a soldering iron or put a steel rod against it and heat the steel rod with a torch to form sort of a heavy duty soldering iron. I don't think you would want to heat the hinge directly with flame. :) I used to install and change out glued in inserts in archery equipment many years ago and would just screw in a bolt, heat the bolt and pull it right out.

Re: Releasing Epoxy.....

#4

Most Epoxies begin to gel at 140 F.


Re: Releasing Epoxy.....

#5

OK, The next question, Is it reversable

Barry Irby

If I heat it and soften it, can I just adjust it and press it into palc e and let it cool or does the heat destroy the epoxy?

I will be using a heat gun. These are wooden hinges so I antisipate trouble driving the heat into the underside of the hinge.

Re: Releasing Epoxy.....

#7

This is going to be tricky.

Keith Newton

The hard part is getting enough heat where you need it without scorching the wood. I would strongly suggest that you practice on a scrap first.

You might try holding it over the spout of a tea kettle, and let the steam provide the heat.

I would plan on mixing more epoxy if it was me.

Re: Releasing Epoxy.....

#8

Re: Heat works extremely well

Howard Acheson

When doing repair work on items glued with slow set epoxy our shop used a heat gun or an infrared heat lamp. Epoxied joints open up pretty easily.