Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

completed A &C couch

Posts

completed A &C couch

#1

completed A &C couch

McKay

I just received the cushions back from the upholstery shop. I built this for my wife for Christmas. I had to give it early as she saw the Cabela's credit card bill for the cushions. I really think that I need to buy my own machine and do my own cushions. The first picture is the bones of the piece.



I have fumed before, but I just used Deftoil medium walnut and three coats of pre-cat lacquer. The color is right and because of the uv inhib. it stays correct. Plus, I don't have the room in my shop this time of year to do fuming.



I draw bored and pegged all of the tenons.



Here is a view of the side.



I built the couch to match the chair that I did a few years ago.



I had hand surgery so I did not get the Stickley side board finished to finish off this suite. The table is a reproduction of the Limbert table that was featured in FW a year ago. (Greg Paolini I think did the story.)

I used QSWO for the piece. I used a dowel plate to make my own dowels from riven oak.

Hope you enjoy.

Re: completed A &C couch

#2

Superb job!!

Bruce, a MN Galoot

I sure agree that it's time to learn doing my own upholstery. A bunch of years ago I made a Morris chair and the bill for the cushions was far more than the rest.

Very nice job on the construction. It's good to know there's a stain that could match the fumed look. BTW, are the arms sawn? The grain doesn't look like it was laminated.

Re: completed A &C couch

#3

arms

McKay

Bruce, the arms were sawn from 6/4 and compression bent over a mdf template. I was careful to line the grain from the center to each side. This helped the shift to look almost like it was a solid piece that was bent.

Thanks for the kind words.

Re: completed A &C couch

#4

Re: completed A &C couch

Thomas Skaggs, Foothills of Mount Level

Nicely done. The couch matches the chair well and I bet both are comfy! Enjoy and congrats!

Tom

Re: completed A &C couch

#5

Very Nicely Done

Mark Mandell - Gone Round In Jersey

You do the upholstery or farm it out?

Legs solid or quadrilaterals?

Re: completed A &C couch

#6

Re: completed A &C couch

Kay Cotton

Excellent work

Re: completed A &C couch

#7

Mark...

McKay

I used four pieces cut on a 45. I had the upholstery done.

Re: completed A &C couch

#8

Re: completed A &C couch

Todd Nebel

Really Nice Work! Did you work from a plan for both the chair and couch? If so, which one and did you make any modifications?

Todd

Re: completed A &C couch

#9

plan

McKay

I built the chair quite awhile ago so I do not remember.I believe that it was a plan from American plan something or other. Like most things I make, if I do use a plan, it is usually to get the proportions of the seat height, back angle, etc. Most commercial plans are really poor. The couch is basically the same as the chair, except I added the cloud lifts and draw bored the tenons. The chair did not have any of that. I used power tools to make the couch, but the chair was strictly hand tools.