Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Unisaw cleaning question

Posts

Unisaw cleaning question

#1

Unisaw cleaning question

Rich Pearson in Mill Creek, WA

My 25 year old unisaw needs cleaning and degunking. Lots of squeals when tilting the blade, hard to crank when nearing 45 degrees, etc.

Has anyone done this without removing the saw table?

I have the table perfectly copacetic to the blade now and really don't want to mess with it.

Thanks

Re: Unisaw cleaning question

#2

JL

Re: Unisaw cleaning question

JL

Yes, I have cleaned a cabinet saw without removing the top. It is a PITA, but it can be done. Wear old clothes and be prepared to take a shower afterwards.

I used kerosene - it is less expensive than mineral spirits. I put a layer of rags in the bottom "chamber" of the saw. I got out a brass bristled brush and dipped it in my little peanut butter jar and scrubbed away. I also had a spray bottle with kerosene. I would recommend removing the belts or shielding them from the kerosene (plastic wrap, rags and tape). Obviously you need a LOT of ventilation.

I did wipe off all of the grease and stuff first.

Re: Unisaw cleaning question

#3

Re: Unisaw cleaning question

Larry Clinton At Frankfort, (Central) Indiana

My Uni did the same thing. I have a left tilt so not sure you can reach the same parts I can. All I did was remove the insert and blade, I used a full pressure air gun (removed the regulator/limiter from the gun) and blew out the gear mechanisms while rotating them. I left my dust collector on to catch the debris. Then I sprayed the heck out of them - again while rotating them - with a dry spray lubricant. That was about a year ago and still no squeaks.

Re: Unisaw cleaning question

#4

Are you to mean it's not supposed to squeak.

Bill Tindall

I need to try that.

Re: Unisaw cleaning question

#5

my 40 year old Contractor saw doesn't

Barry Irby

Squeak, It howls with an ear piercing scream. I need to get some dry lubricant.

Re: Unisaw cleaning question

#6

Thank you!

Rich Pearson in Mill Creek, WA

I will certainly give the compressed air/dry lube solution a try. I have high hopes (not to mention a very good dustmask and dust collector!)