Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Steamer suggestions

Posts

Steamer suggestions

#1

Steamer suggestions

Clementine

I want to try my hand at steam bending - simple stuff like legs for a planter stand, etc. I watched several videos on YouTube and it looks doable, but I have no idea about the size, wattage,etc. Any help on a starter kit?

Re: Steamer suggestions

#3

Second that.


Re: Steamer suggestions

#4

JL

Re: Steamer suggestions

JL

My steamer is a bit larger. I built mine out of exterior grade plywood. It sets on top of a large metal pot. I set the pot on a propane burner (Turkey frier set ups work well). I've got mine sized so I can steam pieces up to 86" long.

You probably don't want something quite so large. But you can always find turkey friers set ups after Thanksgiving for a reasonable price - either new or used.

Re: Steamer suggestions

#5

Re: Steamer suggestions

Paul Leuba

I would like to add a couple things to the fine advice given above re: reading the Lee Valley instructions.

A. The moisture content of the wood to be bent is a fundamental factor. Be sure to stay within the guidelines recommended in the Lee Valley pamphlet. About 15% to 20% as I recall. My experience has been the closer to 20% the better.

B. The recommendation is to steam articles about 1 hour for each 1" of thickness. My experience is that a little longer is better. Perhaps 1 hour 15 minutes per inch of thickness.

C. If the articles will be bent to subtle curves, then it is not necessary to use a steel band to put compressive force on them during bending. However, if the bends will approach or exceed a 90 degree angle, then I strongly recommend the purchase of the steel band compression kit offered by Lee Valley. You risk blowing out the grain on the outside of tight curves if the article is not under compression during the bend.

D. Be sure to have a strong template that the article can be formed to after the bending. Have plenty of strong clamps set up to the right sizes ready to go.

E. After the initial bending, my experience is that the articles should remain clamped to a template for a period of a couple months to allow them to fully dry adhering to the desired shape. Early removal from the template risks springback, distorting the final shape.

Hope this is useful.

Paul in Hunt Valley, MD

Re: Steamer suggestions

#6

Re: Steamer suggestions

TomD

I don't doubt your suggestions on time in the mold are correct, but few have the time to wait, so calculating for springback while imprecise is part of the package.