Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Best thing I've done to my Pipe Clamps

Posts

Best thing I've done to my Pipe Clamps

#1

Best thing I've done to my Pipe Clamps

Barry Irby

I have maybe fifteen pipe clamps that I have collected for the forty some years I have been doing wood working. There are a couple of different brands and styles. The manufacturer changed them over the years and some have a foot on them and many don't. Recently I had some scraps of Baltic Birch Plywood left over so I made wooden jaw liners for them. Cut them to about 5" by 2", drilled about an 1 1/4" hole for the pipe, rounded all the edges (even the holes) with a round over bit, and screwed them to the jaws. Had to drill holes in the jaws for the screws, but it was easy, the metal was fairly soft. If the screws poked through, I filed them flush.

This turns out to be a significant improvement in handling the clamps. Now the all will sit up, at the same height, the handles clear the table, you don't have to use cauls, and when you install them from the top they will sit up in that direction too and the handles clear the table. Wax or otherwise "glue proof" the jaws. Make a few spares. Make the hole loose so as not to bind. A little wider would be OK or better. Solid wood may work as well, but the BB was too pretty to throw away. These are holding up well.

Re: Best thing I've done to my Pipe Clamps

#2

Re: Best thing I've done to my Pipe Clamps

Alex Grigoriev

Even if you file the protruding screws, thet can still poke out. Just use shorter ones.

Re: Best thing I've done to my Pipe Clamps

#3

Re: Best thing I've done to my Pipe Clamps

Barry Irby

You are correct. OTOH, it has not been a problem yet. I was suing what I had on hand and would have bought shorter screws if I were buying them at all.

Re: Best thing I've done to my Pipe Clamps

#4

Ellis Walentine

Here's another clamping idea for you

Ellis Walentine

We used to do a lot of interiors (kitchens libraries, etc.) that required multiple panel glue-ups. I devised a saw horse system that included racks screwed to the tops of equal-height sawhorses, with rectangular slots for our Wetzler bar clamps and 1"⌀ half-circle cutouts for our Jorgies and other 3/4" pipe clamps. The cutouts were spaced on about 6" centers, so you could position clamps effectively for almost any length of glue-up. Our racks were about 6' long, so you could glue up several panels at a time, then just lift them off and stand them against the wall to dry.

Ellis