Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Circle Jig

Posts

Circle Jig

#1

Circle Jig

BrianA

I have seen many circle cutting jigs for the band saw and routers etc. My problem is I do not want to drill a pivot hole in the bottom of my work piece. Any ideas? I thought about a block with a hole with double stick tape but centering the block and adding blocks so the work won't tilt down seem difficult.

Thanks

Brian

Milwaukee

Re: Circle Jig

#2

Re: Circle Jig

Stuart Johnson

Rather than using a small block attach a piece of 3/4 plywood large enough to prevent the piece from tilting. If you want to save on the ply cut strips and tape them on in an "X" pattern with one long and two short pieces with a hole in the long piece.

Re: Circle Jig

#3

JL

Re: Circle Jig

JL

I like Stuart's suggestion.

Another thought - how about a router pattern bit and a template? Tape or attach the template to the workpiece and use a router table. I have a couple of patterns that I have made for various pieces of furniture. I rough trim them and then use the pattern bit to get them to the exact size and shape.

Re: Circle Jig

#4

Re: Circle Jig

eliot d

Do you have a lathe? If so, you could turn what amounts to an annulus from thin stock, tape in to your work piece and use a router with a collar that fits in the annulus. I can explain it further , if you're interested.

Re: Circle Jig

#5

Re: Circle Jig

BrianA

Nope, no lathe. Afraid of becoming addicted ;-)

Brian

Re: Circle Jig

#6

Re: Circle Jig

eliot d

Too bad! I started on a cheap Sears( about $100 ,used, all over the place) and had a great time. But you're right: you get addicted and then the fun and $$$ starts!

Re: Circle Jig

#7

Re: Circle Jig ..Be careful with the template

Mark

I have used this method successfully in the past, however twice while working on a circle and an oval I had it blow out as the pattern bit rounded its way into the end grain...its a lots of work to make the pattern, glue up the blank, and in both cases I had to start from scratch.

Re: Circle Jig

#8

Jesper, Denmark

Re: Circle Jig

Jesper, Denmark

You can mark the circle with compasses and cut it free hand just outslde the line. Finish it of to the line with a sander.

Alternatively cut a full size pattern from scrap ply, MDF or whatever with the pivot hole and tape the workpiece on top. This way the edge is fully supported and does not wobble.

Re: Circle Jig

#9

Re: Circle Jig

Barry Irby

I was going to suggest cutting a similar piece out of scrap and taping it to the bottom like Jesper did, but why not dill a hole in the scrap, double stick tape it to the bottom of your work piece and cut both at the same time? That way the edge of your piece is supported and your should get even less chip out.