Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

How to Cut a 1/16" Groove?

Posts

How to Cut a 1/16" Groove?

#1

How to Cut a 1/16" Groove?

Tom MacGregor

The adjustable sill on my new exterior shop door may have looked like wood from a distance, but proved to be cheap plastic the first time I rolled something heavy over it. I'm reproducing the broken part in hard maple. It requires a 1/16 inch wide slot for the weatherstripping, but I don't seem to be equipped to cut less than 1/8 inch wide. Even Dremel only lists cutters down to 1/8". Anyone have any suggestions?

Re: How to Cut a 1/16" Groove?

#2

Re: How to Cut a 1/16" Groove? *LINK*

Jesse Cloud

If you need a stopped groove (not all the way through), then use a router bit.

If you can plow all the way through your stock, then the thin Freud bits that Bill Tindall likes cut close to 1/16th.


1/16th router bit

Re: How to Cut a 1/16" Groove?

#3

Re: How to Cut a 1/16" Groove?

Barry Irby

A blade for a portable circular saw, (Skilsaw) would probably do that. Mount the blade on your TS.

Also, you can buy wing cutters for a router. Little two or three wing cutters (sort of little saw blades) and you can get them that thin easily. They mount on a mandrel/bit. Once you have the mandrel you can mount almost any thickness cutter you might want. They cut parallel to the base of the router and may not have enough "reach" for you. Not sure how long a shaft you can get.

Re: How to Cut a 1/16" Groove?

#4

saw balde

Bill Tindall

There are saw blades that cut a 1/16" kerf. In fact I normally have one on my saw.

Re: How to Cut a 1/16" Groove?

#5

Re: How to Cut a 1/16" Groove?

AZ in Colorado Springs

If the other suggestions don't work satisfactorily in a hard wood, then you can cut a 3/8" groove and add back a 5/16" filler.

Re: How to Cut a 1/16" Groove?

#6

Re: How to Cut a 1/16" Groove?

john lucas

Make the part wider than you need, cut a 1/8" groove with your table saw. Then rip in in half leaving the 1/16" kerf and glue it back together. You'll probably have to wipe the excess glue out of the kerf but that should be easy with a piece of short cardboard or something similar.

Re: How to Cut a 1/16" Groove?

#7

Re: How to Cut a 1/16" Groove?

Bill Houghton, Sebastopol, CA

My father made a sliding window for our bathroom some years back, using little rollers on the bottoms of the sash, running in hard maple tracks. The tracks lasted about two years. Maple's not a durable wood in the weather - if exposed to water, it'll rot. If this portion of the sill has ANY weather exposure, I suggest you rethink the use of maple. White oak's probably the best easily available hardwood for exterior use - but make sure it's white, not red, oak. Ipe might be another possibility, although I understand it's hard on tools.

Re: How to Cut a 1/16" Groove?

#8

red oak is ok

Bill Tindall

All the commercial sills in my house are red oak. I have a 20 years old red oak gate that is still fine. I agree on maple. In fact any sap wood from any species is not durable exposed to dampness.