Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

OT Clapper held to bell

Posts

OT Clapper held to bell

#1

OT Clapper held to bell

woodenleg

I have a US Navy ships bell(small), that the clapper came off when grandson tried to use it. It was hooked to the bell by way of a metal key ring that rusted through, how do I hook the clapper to the bell the proper way? It does see some use as it is the back door ringer. Thanks, Dave

Re: OT Clapper held to bell

#2

Re: OT Clapper held to bell

John Veerkamp

Is the rusted out piece on the clapper or the bell body? If the bell is the problem then brazing a replacement ring isn't a major problem. If the clapper is bad, maybe constructing a whole new clapper is the most straight forward solution.

Re: OT Clapper held to bell

#3

Re: OT Clapper held to bell

Pete in Holland MI

So.......has the loop inside of the bell failed, or the loop on the end of the clapper?

Is the bell thick enough to drill & tap a screw eye inside?

Use caution doing any brazing. On bells, any un-even heating can risk cracking it.

If it is a real authentic navy bell, it is bronze and pretty heavy. If it is a cheap Chinese knock-off, the brass is of a really poor alloy. I have been undsuccessful doing any brazing of that stuff.

Pete

Re: OT Clapper held to bell

#4

Re: OT Clapper held to bell

woodenleg

It was a steel key ring, that went though a hole in the head of the bell (inside) and then through the clapper. I was thinking some type of belting and bronze nuts and bolts. Dave

Re: OT Clapper held to bell

#5

JL

Re: OT Clapper held to bell

JL

You've got the right instincts. Stay with bronze or brass. The use of dissimilar metals has probably caused the steel to rust more quickly.

I would look for bronze "loops" or chain links. Perhaps a marine supply place would have what you might need.

Re: OT Clapper held to bell

#6

Re: OT Clapper held to bell

Pete in Holland MI

I agree with JL.

Not sure how big this bell is, but possibly a bronze/brass chain cold-shut or loop of sorts. Check your marine suppliers. Might even look into a bronze dog snap which are not too difficult to find too.

If you are in salt air, bronze/brass is necessary. If you are no where near salt air, a heavier steel ring/loop will last for decades.

Good luck !

Re: OT Clapper held to bell

#7

Joe Bradshaw

Re: OT Clapper held to bell

Joe Bradshaw

A piece of heavy cord, such as a starter rope on a lawn mower will work fine. It does not need to be metal.