Re: Vacuum Veneering - the real answer
TomD
"I have a vacuum pump that I use occasionally for a vacuum chuck on my lathe. Its one of the small Gast pumps that is maybe a 1/4 hp and about the size of a shoe box. I can post the model number if that would help, but I'm too lazy to walk down to the shop to get it. Pump has had very little use. I have some tubing and a valve and a vacuum gauge."
Sounds perfect. One would think that maybe there would be a relationship between pump size and effectiveness, but there isn't. The pump isn't creating the pressure. The pressure comes from the atmosphere, all the pump does is move the air out. A very small pump can get it done, but it will either be under power, or under air volume. Neither is normally a problem, particularly talking Gast. Sometimes one needs to us a shop vac to pull the excess air volume out for efficiency sake, but that is rarely a problem at furniture scale.
"I do not have a bag."
Furniture guys have all gone nuts on bags. You can use visqueen, poly bag/sheet. The problem with that is that it may not seal quite as well. Furniture projects, and sub-assemblies are usually small enough that dudes can splash out for the fancy rigs. They are designed around the proposition of not running the motor all the time. Ads huge complexity, but normally worth the trouble at small scale and frequent use.
If you dump that objective, then you do not need an expensive bag. Pretty much all my bagging has been done with 6mil and some kind of caulk or housewrap spline.
"So, jumping ahead for a moment, is it OK to leave this pump running for the hours it takes for the glue to set?"
In boat building we normally run the pump for 8 hours because we are using ambient cure epoxy. With titebond you are looking more like 30 minutes. Curves are not normally a huge problem. Veneer is tough, something like a Birdseye can represent a tiny arch, and be very difficult to press down, therefore might pop up. So just be a little careful, even with flat. Cauls out of plywood can help even out the surface.
Most of these pumps are designed for continuous use applications and will pull for ever. Just be sure they are getting cooled appropriately. Not your gast, but some use flow air for cooling.
"I am going to veneer some flat stuff now but may do curves later. I am thinking of using Titebond because I have it and there would be no creep issues on flat work. I am considering glue to both sides of some 1/8" plywood. So, with Titebond on flat work how long does the stuff stay in the bag and does that kill the pump?"
Limp curves are no biggie, heavy spring back ones like say rocking horse runners - a firehose with positive pressure is a much simpler option.
"Or do I have to get a pressure switch and develop a reservoir to allow for intermittent operation of operation?"
By all means, but you can start now, and put that stuff on order.
"Any Ideas on a bag? Stuff I can get locally?"
Clear plastic drop clothes, or house wrap.