Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Small wine cabinet completed (pics)

Posts

Small wine cabinet completed (pics)

#1

Small wine cabinet completed (pics)

GolfSteve in Calgary

This is a small wine cabinet I built for my Mother-in-law. There was supposed to be a matching wall cabinet, but this project was repeatedly delayed due to the arrival of my two daughters over the past five years, so the wall cabinet has been postponed. Below is a shot of the original design that I sketched up while on an airplane. I followed up with detailed CAD drawings to work out the proportions and dimensions. Dimensions are 28” tall, 26-1/4” wide, by 17-1/4” deep.




It’s made of solid cherry, with cherry, cherry crotch, and maple burl veneers hammered onto Baltic birch panels. The knobs are African blackwood, and the Krenov style door catches are cocobolo.

The finish is a mish-mash due to the extended construction period, but is mostly a coat of shellac, followed by dyed shellac for toning, a seal coat of shellac then two coats of gloss water based lacquer and one coat of satin water based lacquer (Target EM6000). I only recently started using the satin top coat and I really like the sheen. I started out with a French polish finish but eventually scrapped that as my spraying skills improved over the years that this project took to complete. I also found the finishes on older pieces that I had French Polished were being damaged by water stains, scratches, lamp impressions, etc, whereas the Target finishes have been much more durable.

This is the first time I started with 8/4 stock for all the door pieces and resawed book-matched stiles and rails for all the doors. Brusso knife hinges were used (a first for me), and Krenov style door stops (a first for me).


Rear View








Can you find the joint in the top?


Veneer softening:


Drawer slips were used. I put a false divider at the rear of the drawer to give people a warning before the drawer is completely pulled out, and also forms a small hidden compartment.



Everything that could go wrong with this project did, and there is one flaw that I didn’t fix too well when I sanded through a run in a dye-coat where I just said “@#*# it, I gotta finish this thing” and used a touchup pen to hide the flaw as best I could.

The inspiration for the design of my cabinet was from the following photograph that I copied from the Internet years ago and I don’t recall who made it:


And a final shot showing the disaster that was my shop in 2009 when we reorganized the house and cleaned the carpets before my second daughter was born. If you look carefully you can find bits and pieces of this cabinet strewn about the place.


Re: Small wine cabinet completed (pics)

#2

question

Bill Tindall

I like everything about it. I was especially going to comment on the graceful knobs, but then there is the top's profile and the matching crotches (by the way I have a 32 " one I will likely never use) and all else.

Anyway, how are the knobs attached? I am building something that could accommodate a blackwood knob. I have repaired several pieces where the screwed on knob had long since loosened and fallen off. I have thought about a threaded insert into the knob and locktite.?.

Re: Small wine cabinet completed (pics)

#3

Re: question

GolfSteve in Calgary

I never took a photo of the knobs before installation. They are attached using through wedged tenons. For the drawer the post is 7/16" diameter, and I forget the diameter for the door knobs. Below is a picture of the other side of the knob.

One thing I was not sure about was if I should:

1. Fully attach the knobs before finishing (I concluded NO, this would cause problems with spray finishing),

2. Drill the hole in the door before finishing but don't install the knob until after finishing (this is what I should have done), or

3. Drill the hole and install the knob after finishing (this is what I did - but on one hole I got a bit of breakout where the bit exited the hole, and on another hole the forsnter bit got a bit warm and actually bubbled the finish near the exit point).

Anyway, here's a picture of the only knob drilling & installation that went perfect:


Re: Small wine cabinet completed (pics)

#4

Re: Small wine cabinet completed (pics)

Bruce, a MN Galoot

That is very, very nice work, Steve! Having finished my son's wine cabinet last year, I totally commiserate with your toils and tribulations.

BTW, your shop bears a striking resemblance to my own. :D

Re: Small wine cabinet completed (pics)

#5

Re: Small wine cabinet completed

Ray Carson - Lawrenceville, NJ

Very nice Steve, very nice indeed. Cheers !

Ray

Re: Small wine cabinet completed (pics)

#6

She Won't Wine About That Effort!

George Colonel's Workshop-Havertown PA

Good Afternoon Steve,

I wouldn't let all those frustrations be bottled up. Its a beautiful cabinet, and a very original, creative approach to getting a far different look than the inspiration. I hope the new owner is "magnum"-anuous in her appreciation for your litership :D in woodworking..

George

Re: Small wine cabinet completed (pics)

#7

Re: Small wine cabinet completed (pics)

Jim Dillon

I really like the design and your careful attention to construction details: veneering, Krenov catches, drawer slips, wedged knobs, Brusso knife hinges, and even a false drawer panel. All that sure came together to make a very nice cabinet that I sure would be proud of; glad to see you "signed" it. Thanks for the inspiration!

Jim

Re: Small wine cabinet completed (pics)

#8

Oh, George

Mark Mandell - Gone Round In Jersey

I fear a couple of those puns have been corked; not your best vintage that we've come to expect here. ;)

Re: Small wine cabinet completed (pics)

#9

Aw... that's just sour grapes   


Re: Small wine cabinet completed (pics)

#10

Re: Oh, George

Ray Carson - Lawrenceville, NJ

I think the Colonel's puns are aging quite nicely. I'd say he's the liter around here.

Case syrah, syrah, :D

Ray

Re: Small wine cabinet completed (pics)

#11

Re: Small wine cabinet completed (pics)

gary peterson

very nicely done, finish makes it look very smooth.