Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Nibbling to get a perfect fit

Posts

Nibbling to get a perfect fit

#1

Nibbling to get a perfect fit

Bill Tindall

My woodworking epiphany came upon a visit to the College of the Redwoods some years back. I had been an exclusive power tool guy and trimmed things to fit to table saw precision. When I started examining the better made custom furniture it was clear this joinery was more precise and at the College I saw how these fits were made- precise nibbles with hand tools. Hand tools are uniquely suited to nibbling 0.001" shavings off a length or width to eventually achieve a perfect fit.

We have discussed various shooting boards for nibbling. In this post I would like to illustrate another technique.

The picture shows the chest of drawers laying on its back with the molding to be applied laying on the drawer blades and case side.

The task at hand- nibbling the length of the bull nose molding facing for the chest of drawers. The cut out for the "dart" where the drawer blade molding intersects that vertical molding must be precisely located at the intersection of the drawer blade and case side. Additionally, the length of the molding must precisely mate with the case base molding. I found that a 27 degree bevel on the end of this molding satisfactorily intersected the 1/4 round base profile. (Ideally this cope joint would involve a cove to be cut on the end of the molding but I had no way to accomplish this cove nor was it necessary)

The Problem: How to nibble tiny increments off the end of the molding at a 27 degree angle.

The solution to this and other nibbling problems:

I cut a 27 degree angle on the end of a scrap. Clamp the molding to the scrap with a few thousandths of an inch hanging over the end. Mow off the over hang with a sharp chisel in a sweeping arc shearing cut. The angle on the scrap of wood is used as the chisel guide, that is, the flat back of the chisel rides on the bevel of the guide piece so as to fix the cutting angle on the molding.

Re: Nibbling to get a perfect fit

#2

Ellis Walentine

Re: Nibbling to get a perfect fit

Ellis Walentine

Good plan, Bill. You've made yourself a custom, chisel-powered, donkey's ear. And the picture even showed up. (TIP: Use line breaks before and after the tags to keep the photos justified on the left side of your post.)

Cheers,

Ellis

Re: Nibbling to get a perfect fit

#3

Re: Nibbling to get a perfect fit

Michael Wilkins

Does a miter trimmer count as hand work this precise?? I have used one to sneak up on 45 deg. miter joints and those blades leave a shiny cut surface.

Re: Nibbling to get a perfect fit

#4

"Any port in a storm"

Bill Tindall

It"s the result that counts