Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

DVR XP Growler

Posts

DVR XP Growler

#1

DVR XP Growler

Jim Breeden

>( I have a brand new DVR XP that likes to growl at me in action. Emailed

the Teknatool dudes in Florida, got a call back saying, "It has a warranty, etc,

etc, etc., and I could convert it to 220v, maybe that will eliminate the growl".

Changed to 220v, growl still there. Now, when I spin the spindle, with power

disconnected, a "clicking" sound is heard from the front bearing area. Out of

round ball, dead ball, twisted ball - any ideas ?

Re: DVR XP Growler

#2

Re: DVR XP Growler

Bill Houghton, Sebastopol, CA

"It has a warranty, etc, etc, etc."

A brand new lathe - particularly one that costs that kind of money - shouldn't make noises like that, growling or clicking. Contact them again and ask them what they need from you to honor their warranty.

Re: DVR XP Growler

#3

Re: DVR XP Growler

Ken Garlock, Collin County Texas

Greetings Jim. When I first got my DVR it made a small but bothersome noise. My cure was to break it in. I let it run for say 30 minutes at 500 RPM, then repeated at 1500 RPM, and 2500 RPM, and finally at full throttle.

I have slept on it, but I think I also ran a couple 'break ins' in reverse at a moderate speeds. Not the full cycle outlined above, but more like two. One at 2500 and one at say 1200 RPM.

That series of 30 minute runs cured my problem. It may not fix yours, but it would be worth a try, IMHO,

God Luck

Ken

Re: DVR XP Growler

#4

Re: DVR XP Growler

Jim Breeden

:) Thanks Ken - gonna try it.