Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

ws3000 sharpening system

Posts

ws3000 sharpening system

#1

ws3000 sharpening system

eliot d------WebKitFormBoundaryAo1Kz+awUUYH8ShA---

Have you had experience sharpening chisels, plane irons, or lathe tools on one of these? What do you think?

Re: ws3000 sharpening system

#2

Re: ws3000 sharpening system

Jesse Cloud

I have done chisels and plane irons. Its ok, but I can't get as fine an edge as I do on waterstones. Fair enough, though, its fast and easy. I find I actually use the Worksharp when needed as opposed to feeling guilty for not bringing out the stones, wetting them, flattening them, etc, etc. Cleanup is much easier too.

Re: ws3000 sharpening system

#3

Re: ws3000 sharpening system

eliot d------WebKitFormBoundaryAo1Kz+awUUYH8ShA---

Thanks Jesse. I thought it looked too good to be just right. I have the water stones. Tormac, etc. ; so I suppose I stick with these. thanks again.

Re: ws3000 sharpening system

#4

Re: ws3000 sharpening system

Northwest29

IMHO - It's great for carpenter's chisels, plane blades and other 'flat' surface tools. However, since rotation is only in one direction you can't sharpen kinves. I would stay with the Tomek and spent the money elsewhere.

Ron

Re: ws3000 sharpening system

#5

Re: ws3000 sharpening system

eliot d------WebKitFormBoundaryAo1Kz+awUUYH8ShA---

That's pretty much what I have been thinking. Still, I happen to have a bunch of badly used Craftsman chisels to sharpen-- got them at a garage sale -- and I am finding it very time consuming to flatten the large part. The Tormac isn't much good for that.

But I did get a kind of a brain storm: I'm a turner , so why not turn my own flat disks that fit nicely to disk-shaped sanding pads and essentially construct my own scary-sharp system( which is more or less what the WS3000 is anyway)? I would even have variable speed at my disposal and just about any grit sandpaper. I think I'll try it and report back. As for knives, my lathe has a reverse rotation option. Thanks for your input.