Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Replacing ROS H&L pad????

Posts

Replacing ROS H&L pad????

#1

Replacing ROS H&L pad????

Barry Irby

I have a 5" PC ROS. The H&L on the pad wore out. Home Depot had a replacement that is a stick on. I was a little skeptical. I smoothed the balance of the H&L off the disk and stuck it on. Its a peel and stick like a bumper sticker.

I was doubtful about the H&L, but it turns out it REALLY grabs the sand paper. IN fact, it grabbed the sandpaper so well that it pulled the disk off when I tried to change the paper. I was very careful but it came loose any way. The dust got in there and the glue completely failed. I tried cleaning it with lacquer thinner to revitalize the glue and that seemed to help, but not enough.

Any suggestions? I have a spray can of 3M 77 adhesive, but not here at the moment. I actually have two of these sanders and I did this to the other one and it worked well. I suspect I did not get the disk smooth enough.

Re: Replacing ROS H&L pad????

#2

Re: Replacing ROS H&L pad????

Alan in Little Washington (NC)

You are better off just getting a replacement pad from PC.

Re: Replacing ROS H&L pad????

#3

Re: Replacing ROS H&L pad????

John in NM

I used to replace the HL piece for my old Ryobi sander, same trouble you're having. IIRC, once I switched to spray adhesive the dust problem went away. I'd say it's worth waiting until you get at your spray and give that a try, I always had good luck with it.

My local HD's stopped carrying replacement HL discs for the Ryobi's, I'll have to look for the PC version. Never used to have those either (that's why I always bought Ryobi), but these things do change.

Re: Replacing ROS H&L pad????

#4

Re: Replacing ROS H&L pad????

Ron in Sterling, CT

Woodworker's Supply carries the PC H&L replacement pads. I just bought one a few weeks back when they had them on sale.

Ron

Re: Replacing ROS H&L pad????

#5

Klingpors Conversion Pads

Marvin Horn

I've used Klingpor's "Kling-On Conversion Kit" pads for years. About $8 for a five pack. First remove the old H & L pad by gently heating with my handy heat gun, then just peel it off. If necessary clean up any adhesive with mineral spirits, let fully dry. Then just stick on the new disk. When / if the adhesive fails for some reason (dust) I resort to Scotch 77 applied to both surfaces, painted on the sander pad, not sprayed. Works great.

Re: Replacing ROS H&L pad????

#6

Jesper, Denmark

Re: I completely agree.......

Jesper, Denmark

...and remember to puy a new piece of sandpaper on it after you are done and have taken the worn out on off. Forgettig this and mistakenly trying to sand with just the H&L kills the H&L in a very short time.