Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

dent removal

Posts

dent removal

#1

dent removal

Bill Tindall


Invariably during the course of making a cabinet I get dents in it. Often the dent results from setting the piece on a chip of wood. Four items are used to remove the dent. A piece of twisted cotton rag is soaked in water. The end of the soggy twist is placed on the dent and heated with the soldering iron to make buckets of steam in the vicinity of the dent. The steam plasticizes the wood as well as expands the crushed cells. As if by magic the dent disappears. Then the wet spot is dried with a hair drier and the raised grain sanded smooth. I find this hair dryer handy for a variety of shop needs.

The wood is southern cherry. It looks different than northern cherry, or southern cherry grown at high elevation. In a separate post(later) I will describe in more detail the differences.

Re: dent removal

#2

Re: dent removal

Dale Lenz

Sometime if the time is available, like just before a meal or turning the shop lights out for the night, I will just wet the dent. Often when I come back the dent has "filled-up".

Re: dent removal

#4

Do it right the first time

Gary Smyth

The process is a one time only. Once the cells are expanded they are done so save the ding removal until near the end.

Re: dent removal

#5

Re: dent removal

Dick Coers

I once saw a demo of dent removal with denatured alcohol. The guy wet down the dent, then lit the alcohol with a lighter. Very dramatic and affective, but not in my shop. No way! In my shop, I use an old clothes iron for the heat source on the wet rag.

Re: dent removal

#6

Re: Do it right the first time

Bruce, a MN Galoot

Last year I built a wine cabinet for my son, featuring African mahogany frames and panels. Just before I was to begin assembly one of the ends fell over against the threads of a 1" pipe clamp. I wasn't fit company for a very long time.

I trotted out my wife's iron and a wet cloth, dampened the surface first and applied the iron at the cotton setting. The ding was barely noticeable and that only if you knew where to work.

Whoever invented that process should be nominated for sainthood.

Re: dent removal

#8

Woodturners purposely raise dents

john lucas

Dent the wood using something like a rounded over nail. turn the wood down until the dent just barely is visible. Steam the wood and watch the dents raise up. It's pretty cool. I haven't done that in a very long time and don't have any photos to show you. Looks kind of like warts on a frog.

Re: dent removal

#9

Re: Woodturners purposely raise dents

Dale Lenz

That's a great way of knowing your material and making it work for you., thanks for the information!

Re: dent removal

#10

Re: dent removal

Michael Wilkins

Don't let your wife know you are using her hair dryer in the shop. Just like I don't let mine know I am using the iron to iron on edge banding.

Re: dent removal

#11

She found out!

Bill Tindall

Gave me this cheap yellow affair and bought herself a spiffy new model.

I have been banned from the microwave (set it afire drying wood) and the steam iron (turned it red steaming mahogany).