Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Uh Oh, Am I a turner now?

Posts

Uh Oh, Am I a turner now?

#1

Uh Oh, Am I a turner now?

Stephen Kirk

A couple of months ago I took a one night turning class and really enjoyed it. I had an old lathe from my dad and when I tried things at home, well, results varied. I'm a big fan of Jet Tools and I saw that they really discounted the 1220VS midi lathe, and lo, I have one now. I used the regular old 1220 in the class, so I knew it was a good tool.

I figured without some turning skills I was missing an important piece of furniture building. So, I envision having a lot of fun with the lathe. I have an old set of none too sharp tools but even the sample bit of spalted maple scrap I put on it turned quite well.

The lathe is easy to adjust, even the belt changes are pretty quick, while the variable speed adds tighter control. Seems to have enough HP for the standard stuff.

One odd thing I noticed, at the lower speeds I see some wobble on the spur center. Turn the speed up and this seems to disappear. Not having done much lathe work I'm not sure if this is fairly typical or not. I did clean the tapers and I inserted with hand pressure only. Anyone else see runout at low speed?

Re: Uh Oh, Am I a turner now?

#2

JL

Re: Uh Oh, Am I a turner now?

JL

You really shouldn't see wobble in your drive center (spur center). The point should be relatively stationary and stay at that point. Any precession in the point is not good. If it does have a lot of precession - it may be bent or the spur center may be defective.

As spur centers are inexpensive - buy a new one. Another thing to check - does the point of the spur center line up with the point of the live center? Bring the tail stock up to near the headstock and advance the ram and see if the points touch. Rotate the headstock by hand (use the wheel) and see if it moves.

For most lathe work, it may not matter. I had to align my lathe when I had problems with making boxes.

Re: Uh Oh, Am I a turner now?

#3

Re: Uh Oh, Am I a turner now?

Stephen Kirk

I'll check it out and make sure the taper is clean. When you insert the center do you just use hand pressure or tap them in. Hopefully it's just the center. If not, Jet is great at replacing things.

Re: Uh Oh, Am I a turner now?

#4

Re: Uh Oh, Am I a turner now?

John Lucas

Just push the center in. when you put the wood in there and tighten the tailstock it will put plenty of pressure on the drive center to seat it.

You shouldn't see any wobble but sometimes it may be the lights above the lathe. At certain speeds the rotation will conflict with the 60 hertz Ac cycle on the lights and cause spinning objects too look strange.

However like JL said. It should run true.