Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Rusty Bits

Posts

Rusty Bits

#1

Rusty Bits

chrispy400623

I have recently acquired about 30 bits (as in "brace and bits) along with 3 braces. The bits are in fair condition apart from a lot of surface rust, neglected for some 30 years! Is there an easy way to derust them apart from a lot of detailed labour (in the spirals) and something like phosphoric acid. The alternative is to buff them with a wheel as best I can, sharpen them, oil them, and USE them!!!!

Chris

Re: Rusty Bits

#2

Re: Rusty Bits *LINK*

del schisler

sure get this RUST OFF i belive sears carries it now go to this site and than check with sear's This stuff work's i wouldn't be with both.


http://www.woodworkingtalk.com/f24/boeshield-rust-free-t-9-protectant-11833/

Re: Rusty Bits

#3

Re: Rusty Bits

Neal in San Jose

Electrolysis works very well for an application like this. Search the "Article" section for "electolysis" and you'll get a well-written article on how to do it. The only tricky part is finding Washing Soda, but I've lucked out a time or two in the local Safeway in the detergent department. Baking Soda will work in a pinch, but it's slower.

Re: Rusty Bits

#4

Re: Rusty Bits

chrispy400623

Thankyou Gentlemen!

Chris

Re: Rusty Bits

#5

Re: Rusty Bits

doug f, san clemente, ca

Chris - I've had very good results with Evap-O-Rust. Pour some out in a shallow dish, let the bits soak for a few hours and rinse them off. Works great.

Doug

Re: Rusty Bits

#6

Re: Rusty Bits

Jim Smith

Hello, Place them in a plastic pan and cover with vinegar, check them after a half day or so may take longer depending on how much rust, wipe down with scotch brite or steel wool or a rag until dry. You may have to lightly oil to keep from rusting again. Jim

Re: Rusty Bits

#7

Re: Rusty Bits

Ralph Lipeles

Chris,

I've derusted hundreds of square shank bits over the years. I use a wire brush replacing one of the wheels in my buffer. It is about 3/4" wide and does a good job with the smaller bits that do not have very deep flutes and the larger bits where the brush will fit between the flutes. For the in between sizes I use a thinner wheel in my drill pres. When you are finished cleaning, immediuately buff or wax the bits to prevent rusting of the clean, unprotected surfaces.

Ralph Lipeles

Re: Rusty Bits

#8

This related to post above?