Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

finishing burl?

Posts

finishing burl?

#1

finishing burl?

Howard

I’m trying to finish small sections of burl veneer that are less than 1 square foot. My first attempt was padding on an oil such as Danish oil or BLO but the burl just keeps sucking up the oil coat after coat. I can’t get a glossy surface as I would get on non burl wood.

Can anyone recommend another non spray technique and products that I could use?

Thanks

Howard

Re: finishing burl?

#2

Ellis Walentine

Shellac

Ellis Walentine

I would let the existing oil dry thoroughly, then scuff sand with 220-grit and pad on a coat of shellac, about a 2# cut -- or a few coats of 1# cut -- then sand with some 320-grit sandpaper and proceed with the oil or varnish that you prefer. Danish oil and BLO don't really build to much film thickness, so if you want a more substantial film, I'd suggest Waterlox original or General Seal-A-Cel if you prefer a wipe-on finish, or a wipe-on poly-urethane.

Ellis

Re: finishing burl?

#3

Ditto

Mark Mandell - Gone Round In Jersey

On Ellis' suggestion. After sanding, I would blot on a 1# cut, allow to dry for several hours. Then sand lightly, blow off the dust, and blot on a coat 2# cut (rather than 2 applications of 1#). Allow to dry well (4-8 hours depending on "climate") The finish you use for a top coat should be dictated by use. For hand application, I like to use Waterlox gloss for vertical surfaces, but it won't stand up to working top surface (kitchen or coffee table) use. For a surface that will "carry" items, I'd go to the polys. I've migrated away from most of the oil finishes, currently using General's Clear Poly waterborne with cross-linker added. It is, however, really designed for spray application; haven't tried to hand-apply the stuff.

hth

Re: finishing burl?

#4

Re: finishing burl?

Cecil Nickerson in Halfmoon Bay

I finish big-leaf maple burl pieces (small tabletops, island tops etc.) with a few coats of 1+lb. orange shellac, lightly sanding between coats. The topcoat has been Tried and True original (beeswax and heat-catalyzed linseed oil). The neat thing is that the shellac pops the figure nearly as much as oil and when the Tried and True is applied, the oil migrates through the shellac and you can see the figure glowing more brightly as you apply the topcoat. The finish is not as durable as wipe-ons but looks great (the whole point) and is easily repaired and maintained.

Cecil