Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Double tenon question?

Posts

Double tenon question?

#1

JL

Double tenon question?

JL

I want to attach some legs to some stretchers. The legs are ~1 5/8" x 1 3/4" or so. I was going to make the stretchers ~1 5/8" x 1 3/4" also. I was considering using double tenons for this application. I figure double tenons would be more secure, etc., etc.

Question - if I decide to use double tenons I was thinking of making them ~1 1/4" x 3/8". This would make my mortises the same size. If I do this, the amount of wood on the outside would be ~3/8" on the "sides" and 1/4" on the top and bottom. The amount of wood between the two mortises would be on the order of 3/8" or less. Is this enough?

Should I make the mortises and tenons less thick? Make them say 5/16" or 1/4" instead?

Re: Double tenon question?

#2

Re: Double tenon question?

Jesse Cloud

Wouldn't change a thing. Those joints will be very strong!

Re: Double tenon question?

#3

Re: Double tenon question?

paul in AZ

If you REALLY want to overkill you could also pin the joint with a 3/8" or so dowel. I often use pinned M&T for the decorative effect as much as anything else.

Re: Double tenon question?

#4

Re: Double tenon question?

FredD

I would use a single 1/2" Tenon which gives about the same sixe shoulder on each side and is easier and just as strong then the thinner double Tenon and requires much less fussing.

FredD

Re: Double tenon question?

#5

JL

Gee, an excuse to get another router bit...

JL

Sounds good to me.