Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

LACQUER FINISH

Posts

LACQUER FINISH

#1

LACQUER FINISH

JERRY DRAPER

Can I apply Deft Lacquer spray from a can over Danish Oil?

Re: LACQUER FINISH

#2

Yeah, But . . .

Mark Mandell - Gone Round In Jersey

Deft (and most all the rattle can stuff) is pretty low on solids meaning you're going to be applying a lot of thin coats to get any kind of build.

What's the item?

Re: LACQUER FINISH

#3

Re: LACQUER FINISH

FredD

Yes , but the instructions on most Danish finish say let dry fro 72 hours prior to the finish application.

If the item is small, Deft in the spray can works fine , less mess then a gun application and you can do four to five coats in less then a day which should be enough.

Do two coats and finely sand , then two or three more without sanding, makes a nice finish

FredD

Re: LACQUER FINISH

#4

Re: LACQUER FINISH

JERRY DRAPER

Item is a small Bracelet Box & I was concerned about adhesion. Thanks to both of you for your advise.

Re: LACQUER FINISH

#5

Just For Laughs

Mark Mandell - Gone Round In Jersey

and giggles, you might consider dulling the surface with 600 or above (or 00 or 000 steel wool) so that your lacquer has a less-than-glossy surface to grab. If you wool it, either use oil-free wool or wipe it with a little naphtha to remove the very light oil used to keep steel wool from rusting in the bags.

Re: LACQUER FINISH

#6

Re: Yeah, But . . .

Phil Joines

Krylon in the can is much higher in solids.