Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Kicking around ideas for an "angel" display table

Posts

Kicking around ideas for an "angel" display table

#1

JL

Kicking around ideas for an "angel" display table

JL

The prayer shawl ministry group has an "angel" made out of grape vine. It is "decorated" with hunks of yarn and stuff. They now want to display it in the Parish Hall. Fine.

The "feet" or "base" of the angel are basically the ends of grape vine.

My basic thought is to have a table with either a lip or an inlaid "bead" so the angel won't go "skittering" off of the table. Then I got to thinking - what about wood movement? I won't have a problem along the grain with wood movement in a solid table top, but I will have a problem across the grain.

So - what do ya'll think about gluing up the wood for the table top and cutting off the ends and the sides and then using that wood for the bead? I could put a reasonable profile on the bead. Not too much of a problem along the grain. Do you think the bead made out of the end grain pieces would be too weak?

Another thought was to just make the cross direction beading material the same way that I was making the other beading material, but make it "floating" and anchored only in the middle. I'd have it protrude slightly past the other beads. It would be even during certain seasons.

Re: Kicking around ideas for an "angel" display table

#2

Moses Yoder

Re: Kicking around ideas for an "angel" display ta

Moses Yoder

Sounds like the ideal use for plywood, banded around the edges.

Re: Kicking around ideas for an "angel" display table

#3

Re: Kicking around ideas for an "angel" display ta

Yonak

JL, it seems to me that if you have the grain of the beading going the same direction as the grain of the table top you shouldn't have any problem with movement. I would sink the beading into a groove to keep it in place if you can and as long as the beading doesn't protrude excessively above the table top or is too thin, I would think the cross-grain beading should hold up.

Did you consider building the table top using frame and panel construction where the edges of the frame would act like your beads ?

Re: Kicking around ideas for an "angel" display table

#4

JL

Re: Kicking around ideas for an "angel" display ta

JL

Excellent thought. That would be easier to do.

One reason why I'm reluctant to do plywood is that I always sand too much.

Re: Kicking around ideas for an "angel" display table

#5

Wouldn't worry about the wood movement

John Cotten

If the wood movement were that big of a problem, lamps, glassware and books would be falling off of tables and shelves all the time. A small bead will suffice just fine, the bigger concern is going to be small hands and little fingers, or if the floor shakes like our old church, the table might vibrate enough for the angles to move. Otherwise, solid top, small bead, you should be fine.

The larger portion of problem with wood movement is keeping furniture from cracking (table tops, joinery, or legs) or coming apart from wood movement. Almost all woods move only a small fraction of an inch over several weeks or months, usually seasonally related. Go forth, build, share, and enjoy the accolades from your brothers and sisters from church...and if your really lucky, Granny Hagan will bake you one of her famous home made pies or cakes as a thank you....