Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Countersunk holes

Posts

Countersunk holes

#1

Countersunk holes

Michael Mann

Hello, I'm working with 2x4's and 2x6's douglas fir to built furniture. To connect the lumber I countersink the holes with a 1" forstner bit. After that I change the bit to drill a 3/8" inch hole at the center of the hole. The 3/8" hex screw with washer is not sticking out of the wood anymore. I'm looking for a bit which can do this drilling in one step. This will save a lot of time and drillpress ajustments - THANKS - Michael

Re: Countersunk holes

#2

Google "Counterbore for sale" *LINK*

Bill Houghton, Sebastopol, CA

One possibility below. I've had no contact with this company, it was just the first likely looking prospect.

Countersink: for flathead screws. Hole is tapered at the same rate as the underside of a flathead screw.

Counterbore: for what you're doing, and other such applications. Hole is cylindrical and can have a flat bottom, as in your case, or a tapered bottom, when, for instance, you're sinking a flathead screw far enough below the surface to cover it with a plug.


http://www.morriswoodtool.com/Counterbores.htm

Re: Countersunk holes

#3

solution

Bill Tindall

There is a company in Morristown TN that makes these bits. If you can' t find them email me and I will try to locate them. Or call Misenheimer in Morristown 423 587 4300(saw shop) and ask for David Purkey and he will know the place. I may have just this bit as I used to make a product that did this operation. If I do I'll sell it.

Re: Countersunk holes

#4

Ellis Walentine

Cheap solution

Ellis Walentine

You can buy one of those two-stage bits that Bill suggested, or grind an inexpensive 1" spade bit to a stepped profile.

Ellis

Re: Countersunk holes

#5

Re: Cheap solution

Iw

I just had to drill about a hundred. Used a spade bit of right size then drilled the hole. Used two drills so I didn't have to change bits. Put apiece of tape on spade for depth.

Re: Countersunk holes

#6

Moses Yoder

Re: Cheap solution

Moses Yoder

How would you go about doing this if you had to do 5000?