Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Safety first

Posts

Safety first

#1

Safety first

Pat Evans

The last time I did a lot of repetitive router table work with small stock, I came dangerously close to an accident. I thought the jig I had to hold the stock would keep my hands away from the bit, but fatigue led to a slip that was almost disastrous.

With 200' of small glazing bead to mill, this time I used Board Buddies, feather board, and bit guard to make sure my hands were no where near the bit.


Re: Safety first

#2

Re: Safety first

Ken Garlock, Collin County Texas

Good morning, Pat. As one famous person once said, 'I feel your pain'/and or concern.

Several years ago I made some shelf brackets to use on shop shelves. The routing called for a simple round over of the pieces. Well, I made it to the last bracket and the last of ten cuts on the router, the piece finished routing before my hand did. The result was a nice clean pealing of the skin down the side of my right hand just below the finger knuckle. Fortunately the skin hung on and my wife, an LVN, folded it back up and put some anti-biotic on the it, and then wrapped me up It took about 2 weeks of daily dressing to get it all healed up. I can't even find the scar today.

I thought I was being careful, but.........

Ken

Re: Safety first

#3

Re: Safety first

Tony - Memphis

Sorry you got injured, but I appreciate hearing the warnings. I am always concerned that I wil get too comfortable and therefore careless in the shop. I've been at it for around 15 years now....perfect time to get too confident! Good thing is, I'm not a real confident person. Something I always remember is the question posed by a woodworking instructor - "Where is your hand going to be/go when the wood gets tossed by the machine?" Can't be too careful.

Thanks,

Tony