Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

rough cut wide plank flooring

Posts

rough cut wide plank flooring

#1

rough cut wide plank flooring

Donald Swann

I have a barbershop that will be remodeled to a western look, the exterior is almost complete, the interior is about 5% complete! I have purchased over 2000 board feet of old rough cut barn lumber for walls and floor, some are pine,but most are oak. for the floor I would like a an old time dull look, not a gloss. Mind you that the boards can be individually worked on outdoors and covered and left to dry and put down on the floor when complete, in case you recommend tung oil. What process would you recommend for this type of project?

Re: rough cut wide plank flooring

#2

Moses Yoder

Re: rough cut wide plank flooring

Moses Yoder

The barn wood I have installed was pretty rough from weathering. I have never used it for floors but they do use it for floors in barns so I assume it works. When I installed it I went over it with a wire brush to get any loose paint off (possibly leaded) then blew it off with an air nozzle, nailed it to the wall and called it good. If you are going to finish it I would recommend sanding it smooth, which could be done before or after installation on the floor, preferably before on the wall, and then using my favorite mixture of turpentine, poly, and linseed oil which can take several days to dry between coats. If I was doing it myself, I would just install it rough on the floors and the walls and not finish it. It would actually be much more authentic that way. You can use a good vacuum to clean it if it gets dusty in a few years, or just plug in the leaf blower and go to town.

Re: rough cut wide plank flooring

#3

Re: rough cut wide plank flooring

FredD

Sounds like a poor choice of flooring for a Barber Shop.

Sweeping hair trimmings off of that should be a lot of fun.

FredD

Re: rough cut wide plank flooring

#4

Re: rough cut wide plank flooring

Donald Swann

I seldom get hair on the floors because I use a vacuum attached to the clippers. I do have a picture of what kind of floor I want on my computer, I dont know how to put it in here, it calls for URL from the internet. Any suggestions?

Re: rough cut wide plank flooring

#5

Clint Searl

Brylcreme....

Clint Searl

A little dab'll do ya :D

Clint

Re: rough cut wide plank flooring

#6

Re: Brylcreme....

FredD

Use Wildroot Cream Oil Charlie

Start using it today

it's non Alcoholic Charlie

You will have a tough time ,keeping all the gals away.

or something like that.

FredD

Re: rough cut wide plank flooring

#7

Re: rough cut wide plank flooring

Andy Halterman: Carving the singletrack

We do lots of floors just like what you want to do in your shop. We lightly sand them and then use a product called Woca Oil for the finish. Much easier to deal with than tung oil since it's VOC free. One caveat is that the rags you wipe down the floor with need to be taken outside and spread out. This stuff is more volatile than stains. Don't ask how I discovered this tantalizing tidbit.

http://www.woodcareusa.com/

The stuff is pricey but my customers have been very happy with the look it achieves.

Good luck.

Andy Halterman

A nice break from the heat today in Hendersonville, NC�