Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Rabbeted dadoes... joint strength?

Posts

Rabbeted dadoes... joint strength?

#1

JL

Rabbeted dadoes... joint strength?

JL

I'm planning on making music shelves with sliding dovetails for the top, bottom and a middle shelves. I was going to use shelf pins (1/4") for the other shelves.

The other thought that I had was using rabbeted dadoes. The only trouble is that I might have to use screws - which I really don't want to do. I would plug the screws of course.

Re: Rabbeted dadoes... joint strength?

#2

Ellis Walentine

Rabbet or dado?

Ellis Walentine

I'm not understanding the terminology, JL. Is it a rabbet or a dado? A dado (cross-grain groove) would be susceptible to breakage along all that short grain, although so would a sliding dovetail, so I'd be wary of using either of these joints. Regular dovetails, OTOH, would be superior in every way. A rabbet or a dado, as you suggest, would require some kind of mechanical fasteners, which may or may not be an acceptable solution to your design requirements.

Ellis

Re: Rabbeted dadoes... joint strength?

#3

JL

Re: Rabbet or dado?

JL

Maybe I'm not clear on the terminology.

The dado would still be a cut in the board. What do you call the portion that fits into the board? If I were to rabbet each side of the board (say 1/8") on each side and put it into the dado - would that be "strong" enough?

I was thinking about doing either a sliding dovetail or a dado (with rabbets on the shelving boards).

Are you saying that the sliding dovetails on the shelf board ends might not be strong enough?

Re: Rabbeted dadoes... joint strength?

#4

Dale Lenz

Re: Rabbet or dado?

Dale Lenz

Built a book cabinet with 42" span, dovetailed the shelves to sides, use small diameter dowels through the sides into shelf material, w/contrasting wood wedges into the dowels' ends. Could use the dowel trick on either joint, dovetail or dado w/ rabbet. A well fitting DT would be the strongest and possibly more attractive.

Re: Rabbeted dadoes... joint strength?

#5

Re: Rabbeted dadoes... joint strength?

AZ in Colorado Springs

I think I understand what you're describing. I don't think you'll gain any strength -- you'd have a series of 1/8" or 3/16" steps, that have to be carefully cut to fit tightly (if you have rabbets on both sides of the dado), then the additional gluing surface area are each end grain to long grain joints.

If you have a rabbet on just one side of the dado, it'll be a bit easier to cut, but the same situation with respect to the gluelines -- end grain meeting long grain.