Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Chicken or egg. Epoxy and Oil finish

Posts

Chicken or egg. Epoxy and Oil finish

#1

Alan Young

Chicken or egg. Epoxy and Oil finish

Alan Young

I am working on a chess table/case. The playing surface will be surrounded by a frame. The frame is approx 1/4" higher than the board and I want to use this epoxy mirror coat to finish the playing surface.


Sort of like pouring an ice rink where the rink gets the epoxy and the boards etc get the oil finish... The rest of the frame and case will get an oil finish. There is no information on the packaging-but I need top know if the epoxy should go on at the end of the finishing process or before I oil everything...

-Alan

Re: Chicken or egg. Epoxy and Oil finish

#2

thoughts

Bill Tindall

I suspect the epoxy will not stick to the oiled wood and the oil will certainly not take on wood that has a film of epoxy. I suspect that the oil could dull the cured epoxy. This line of thinking, if it is not flawed, would conclude to oil the "boards" first and maybe tape off the ice rink so as to not risk getting oil on it. Then pour the "ice".

Re: Chicken or egg. Epoxy and Oil finish

#3

Clint Searl

Re: Chicken or egg. Epoxy and Oil finish

Clint Searl

Why does it need an epoxy coating? If it's wear that you're worrying about, a water borne floor finish with an AlO additive like Varathane is more than adequate. If it's tough enough to walk on it ought'a be OK for a chess board.

Clint

Re: Chicken or egg. Epoxy and Oil finish

#4

Steve Strickland

Re: Chicken or egg. Epoxy and Oil finish

Steve Strickland

I might be off base here but what's wrong with dowelling the rails in from the bottom? Finish both pieces first then dowel 'em together. Seems easy enough to me.

Re: Chicken or egg. Epoxy and Oil finish

#5

Alan Young

Damage Control....

Alan Young

From the dept of haste makes waste..This was to be a graduation gift back in May. At the time I was hurrying to get it finished for the graduation date. as it happens I gave up on finishing it for the graduation date and will present it for a house warming party in August....but back to the problem..the board is maple and walnut veneer over BB ply. In my hast to finish I realized too late that the veneers are not of equal thickness. There is a slight level difference between the two color squares. So my remedy was to flood a layer of the epoxy over the playing surface-the boarder will keep the epoxy from leaving the playing surface....

I think I need to apply the epoxy before the oil......

-Alan

Re: Chicken or egg. Epoxy and Oil finish

#6

Clint Searl

Smart solution

Clint Searl