Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Jointer cutterhead speed

Posts

Jointer cutterhead speed

#1

HapaJeff

Jointer cutterhead speed

HapaJeff

I have an old Crescent 8" jointer with a 2-knife cutterhead. I'm finding that, at its current speed, the jointer cuts just too slowly, and a little too rough.

I've looked into changing the cutterhead to a three-knife or a helical, but the cost is prohibitive.

The cutterhead is very close to 3 1/2" in diameter, and has been retrofitted to run on ball bearings. After doing some math, I've found that my cutterhead rpm is approximately 3520, resulting in 7040 cuts per minute.

As I've indicated, changing the cutterhead isn't an option. How fast can I safely run this 3 1-2" head by changing pulleys?

-Jeff

Re: Jointer cutterhead speed

#2

Re: Jointer cutterhead speed

Jerry Gibbs

I'm looking at plans for a jointer that uses a 3 blade head turning at 5000 rpm. the cutting arc is about 3". Safety can involve the construction of the cutter head, shaft diameter, as well as the mounting of the blades. I suspect your 2 blade limitation causes a rougher cut. Since 8" jointers are significantly more expensive than 6", I would investigate a 3 blade head further. Hope this helps. Jerry

Re: Jointer cutterhead speed

#3

Jim DeLaney, Austintown, Ohio

Re: Jointer cutterhead speed

Jim DeLaney, Austintown, Ohio

For a three-blade head, maybe ask around for somebody who's converted from an original to a helical head, and has the old one laying about. There might just be a deal to be had.

Maybe post a message on the "Looking for Something" forum here?

Re: Jointer cutterhead speed

#4

Re: Jointer cutterhead speed

del schisler

the only found this on a 8" jointer but with 3 knive's nothing on 2. I don't see any reason this wouldn't be ok at that speed.The head speed 7,000 rpm's SPECIFICATIONS: Model 60A, 8" Jointer

Table ............................................................................................................................. 8-1/2" x 72"

Head cutting arc .......................................................................................................................... 3"

Knives (3) H.S. steel ............................................................................................ 1/8" x 11/16" x 8"

Speed of head (maximum) ............................................................................................. 7,000 rpm

Knife-cuts-per-minute .......................................................................................................... 21,000

Maximum depth of cut .............................................................................................................. 1/2"

Maximum rabbeting cut ..................................................................................................... 1/2" x 8"

Fence size overall ...............................................................................................................4" x 36"

Height, less stand ................................................................................................................ 12-1/2"

Height, with stand ................................................................................................................ 35-7/8"

Motor recommended ..................................................................................................... 3/4 to 2 HP

Weight, domestic crated with stand & motor ....................................................................... 584 lbs.

Re: Jointer cutterhead speed

#5

Re: Jointer cutterhead speed

JMOHNIKE

It sounds as if you have an older system. My main concern is how are the knives held in place? By increasing the speed of the cutter head you may be asking for trouble as the knives may not hold at higher RPM's which could create a big OOPs moment. If the only problem you are having is the quality of the cut, I would suggest slow down your rate of feed. A sort of rule of thumb that I use, for most tools, is about 8,000 feet per min. for cutter head speeds. Even with a new joiner, fresh out of the box you would have to adjust you rate of feed based on the type of wood you are useing the depth of cut and the width of cut.

Joe